5/7 drop c3500 offset ?

[Glenn8Weiss]

I've got a 93 C3500 I'm planning on doing a 5/7 or 6/8 static drop on soon.. my question is what offset will I need for 20 x 8.25 with 265/50/20 ? I will roll inner fenders.. I want as flush as I can get without rubbing while tucked.. any suggestions will be greatly appreciated..
6.0 LS swapped, was a 6.5 with 120k

You must be registered for see images attach

You must be registered for see images attach

 

[best97obs]

This would most likely be an @618 Syndicate question. He has a killer dually and he knows just about everything on em.

 

[618 Syndicate]

This would most likely be an @618 Syndicate question. He has a killer dually and he knows just about everything on em.

More of a @someotherguy question. I'm not a wheel expert at all.

Are you planning on direct bolt on 20's?

 

[Glenn8Weiss]

Yes

 

[618 Syndicate]

Then I'd ask the manufacturer what they recommend. The rear will tuck fine, but you may need to roll or trim the front.

 

[Scooterwrench]

Sounds like a job for a baseball bat. Were you planning on losing the inner fenders?

 

[Glenn8Weiss]

Depends on clearance.. will modify if necessary, but not running without some inner fender.. too much $$$$$ in the engine bay...

 

[618 Syndicate]

Sounds like a job for a baseball bat. Were you planning on losing the inner fenders?

Inners are fine with a 5/7 and that tire setup.

 

[618 Syndicate]

Truck looks great, will look even better on the ground!

 

[Glenn8Weiss]

That's what I figured.. 30½" tire ...