Kyle89
10-17-22 sober date
So I will know for sure tomorrow about trading my 95 k1500 excsb for this exclb 1989 was a 454 truck has a 1981 th400 and a rv readend so I'm guessing 4.56 gears 2GCHC39N0K114942 is the Vin but I can't find the build sheet on compnine.com for fhe Vin decode I get to keep my 305 and computer from my tbi 95 so can hopefully use the prom chip or whole computer exhaust and anything to make the motor run in the truck it needs a break line master cylinder abs pump and proportioning valve and it's good to go I'm throwing 500 fo boot on the deal my cousin wants the nv3500 for his 88 1 ton 4x4 ...he won't beat on it so with a stock sbc he should be good I don't think it's a bad deal since my 95 has a bent frame and front clip is trash and it gives me a good base to build a tow pig has factory over loads he wants for his 4x4 ... he can keep them cause the rv leaf pack is more than enough for what I want right now cause I'll put heavier overload springs on when it's time ... if all goes well it will be getting a gooseneck ball maybe a 5th wheel aswell... 305 yes ik small but it's just to get started .... plans are down the road are subject to change and no specific order...
Build a healthy sbc low rpm stump puller till I can afford building a big block.... I like the idea of a 427 but it may get a mild built 454
Nv4500 (is a must)
Locker for the rear
Load leveling for the read
(Possible 2/4 lower kit)
Aluminum reserve/ transfer tank
Dual battery setup
Massive alternator
2 decent size power inverters
Tool/ equipment bed side or below bed top boxes for chains binders straps etc.
Trailer breaking
( have been considering possibly making it a wrecker/ roadside service truck but if I do that ... out goes the gooseneck but I can always start with a trailer and upgrade)
It's ultimate goal is to be a moneymaker
Like I said some goals may change because ...can't have a lowered wrecker....
I'm open to suggestions and ideas but the ultimate 2wd tow/haul truck has always been a goal with any truck and now I have a 1 ton to start with please no bashing ... this is a complete different mindset and a old goal /dream of mine that j have never had a chance to take on ....but it's time
Build a healthy sbc low rpm stump puller till I can afford building a big block.... I like the idea of a 427 but it may get a mild built 454
Nv4500 (is a must)
Locker for the rear
Load leveling for the read
(Possible 2/4 lower kit)
Aluminum reserve/ transfer tank
Dual battery setup
Massive alternator
2 decent size power inverters
Tool/ equipment bed side or below bed top boxes for chains binders straps etc.
Trailer breaking
( have been considering possibly making it a wrecker/ roadside service truck but if I do that ... out goes the gooseneck but I can always start with a trailer and upgrade)
It's ultimate goal is to be a moneymaker
Like I said some goals may change because ...can't have a lowered wrecker....
I'm open to suggestions and ideas but the ultimate 2wd tow/haul truck has always been a goal with any truck and now I have a 1 ton to start with please no bashing ... this is a complete different mindset and a old goal /dream of mine that j have never had a chance to take on ....but it's time