Search results

  1. M

    A/C cool not cold

    Got the truck back today. Mechanic said there was air in the line and a little crud in the orifice tube. Figured the backyard mechanic that did the compressor swap before didn't flush it good enough. Cost $95 for him to change the tube and recharge. He did say that since it was originally an r12...
  2. M

    Can I adjust door to shut tighter?

    Good idea! I'll give that a try. I do know the door is sagging a bit, so I've bought the new bushings and pins. Just need the time to work on it.
  3. M

    A/C cool not cold

    I'll check it out. I assumed it was working because it would go to hot.
  4. M

    Will a hard tonneau from a 2000 fit?

    That's what I thought I remembered reading. Well dang! Thanks for the help
  5. M

    Will a hard tonneau from a 2000 fit?

    Trying to see if a hard tonneau from a 2000 standard bed fit my 92 standard bed?
  6. M

    A/C cool not cold

    Checked it out today and it's closing all the way. I'm going to take it and have the ac shop check levels, since I'm using a basic gauge on low side.
  7. M

    Wire getting really hot....

    Well I had another blower and swapped it out. I noticed it was only getting hot on high fan. I went ahead and redid the connection and it doesn't seem to be getting hot. I traced the wire to the harness that goes through the firewall.
  8. M

    Wire getting really hot....

    OK I'll check it out. The A/c compressor is brand new. I'll check the blower motor and the circuit and see where I stand.
  9. M

    AC recirculate actuator location?

    Not sure if mine is out or not. I know I can hit the button and you definitely hear a difference in the air flow, but temp doesn't change. My ac is not getting cold enough and someone suggested it could be flap not closing all the way.
  10. M

    AC recirculate actuator location?

    Sounds about par for the course. Thanks for the help!
  11. M

    Wire getting really hot....

    The other day I was working on my ac and I noticed a harness had melted behind the glove box. I went to the junk yard and looked for a new one. The first two I looked at were melted just like mine. I eventually found one and spliced it in, but noticed today the red power wire is getting really...
  12. M

    AC recirculate actuator location?

    Can anyone tell me where the recirculate actuator is located? I see the actuator for hot and cold but that's it. Thanks in advance.
  13. M

    A/C cool not cold

    I checked it out a little today. I have a definite change in temp and sound when recirculate is pressed. I did notice the other day that I ran over something particularly smelly and it blew threw the vents even with recirculate on. I did notice that when the air is on I can feel cold air...
  14. M

    A/C cool not cold

    I'll have to check into it. I know that when I hit recirculate, it does get colder and there's definitely a sound difference.
  15. M

    A/C cool not cold

    I recently had the a/c compressor, dryer, and orifice tube replaced because the compressor was leaking Freon. It still does not blow cold. I checked the vent temp and it was reading about 62 degrees. Freon is still showing full and I went in and cleaned the evaporator grille out and cleaned off...
  16. M

    Can I adjust door to shut tighter?

    Okay tried it out and it didn't work, but I did notice I have a little slack in the door. I'm going to go ahead and swap the door pins and bushings to be safe.
  17. M

    Can I adjust door to shut tighter?

    Ok guys I'll give it a try this evening and post back. Thanks for the help!
  18. M

    Can I adjust door to shut tighter?

    I'm having an issue with wind noise on my drivers side. I looked and it has a bigger gap between the roof and the body than the passenger side. When driving down the road, I can pull against the door and make the sound quit. The weather stripping appears fine and the latch still has the rubber...
  19. M

    A second chance on my Dad's Mark III

    That's awesome. I had planned in buying more until I got these cleaned up That's awesome! I planned on getting more, but was happy to be able to clean these up. I had to strip the clear coat off and was surprised to see bright and shiny aluminum underneath. Even when Dad first got the truck the...
  20. M

    A second chance on my Dad's Mark III

    Current:
  21. M

    A second chance on my Dad's Mark III

    I'm just about finished breathing new life into my Dad's old 92 Mark III. My Dad bought it in 95 and kept it until he gave it to my brother in 2008. My brother didn't take very good care of it and sold it to me in December 15. Dad passed away in 2014 and I wanted to bring it back to the way it...
  22. M

    88-98 Bucket seat alternatives

    I installed my work around for the gap between the Caprice seats today. The color match is better than the pic shows. I made it removable , the kids cut between the seats like captains chairs now. it's nice to get some cupholders now.
  23. M

    88-98 Bucket seat alternatives

    ok thanks for letting me know. I know the Mark III seats are torn where you sit and it has a white cloth or felt backing. Would that mean they are vinyl?
  24. M

    88-98 Bucket seat alternatives

    Ran into an issue this weekend. My truck has maroon leather 40/20/40 seats. I found a set of seats out of 95 caprice that looked brand new and matched the leather perfectly. They were 60/40 style. The issue I ran into was that my seats are not factory, the truck is a Mark III package, so the...
  25. M

    Double Din installed in OBSRC

    How much did you have to mod the console to fit the dash and floor?

Latest posts

Staff online

Members online

Total: 1,106 (members: 16, guests: 1,090)

Forum statistics

Threads
64,476
Messages
1,394,737
Members
51,755
Latest member
GriffisClnCo

Share this page

Top