Just as the title states, Is it possible for a 411 PCM to revert back to GM factory settings? I have a swap going on (have a thread in street builds) and have had the truck running and everything. only problem was it was idling really rough and had a after fire going on popping real loud and...
Another update for everybody, Ive been pretty busy but have managed to continue progress. At some point I would like to get the A/C in working order so I had to replace the damaged Evaporator Coil in the dash ( the line going through the firewall to connect to the dryer was damaged.) This...
A little update for everyone. Work on the truck has been slow but I have accomplished a few thing in recent months.
Here I was re-pinning the wiring harness to accommodate the new 411 PCM
Here I was routing the harness back into position in the engine bay.
411 PCM, Fuse Block, and...
So I have been working on creating a pin-out that will work with my current project. I have tried several times to contact lextech and get a copy of his to cross reference and have had no luck. I wanted to give him a chance to get back with me as I know he sells kits and such upon e-mailing the...
Hello everybody, Been working on bringing a truck back from the dead since September 15. Truck is a 97 K1500 4WD. Picked it up from a farmer who had blown the engine in it. It was originally a step-side truck however at some point the previous owner had a rear blowout and tore the passenger...
Just wanted to say hello to everyone here. Got myself a project I've been working on for a few months. 1997 K1500. Bought the truck on the cheap with a blown 5.7 pulled it, replaced with my built 5.7 out of my camaro as I plan to replace it with a LSX swap in the future. Depending on the...