Recent content by montess85

  1. M

    Gooseneck Pictures

    Nice truck. I just got a set of airbags for mine. I tried putting them in but couldn't since I lifted it. Waiting for my spacers for the kit now.
  2. M

    1999 CCSB drive line vibration after lift

    Well it's been at the drive line shop for almost 3 months. They say there always to busy to mess with it. I guess they tried a few things but it was worse than when it came in. They tell me it's perfectly fine to drive. And that they will let me know when they will have time to look at it...
  3. M

    1999 CCSB drive line vibration after lift

    Well I happen to have a friend who owns a drivline shop locally....I ended up dropping it off there....I'll see what he comes up with....
  4. M

    Horrible grinding noise - Can't seem to figure out

    I assume the new compressor came with a new ac clutch?
  5. M

    1999 CCSB drive line vibration after lift

    I put a RCD 6 inch lift in my truck and I have a slight vibration on takeoff. I also feel a vibration in my feet through the floors while doing highway speeds. I just had the drive shaft rebuilt with new u joints and a new carrier bearing. Also had it balanced. The shop told me it was a...
  6. M

    98 chevy 3500 crew cab 4x4 engine advice

    I dont know about your area but the local pick and pulls charge 200 for a engine with accessories....Call aroud junk yards and see what they have....
  7. M

    Gooseneck Pictures

    Who here uses a gooseneck and what kind? Lets see some pictures?
  8. M

    What have you towed lately

    Those axles seem really far back.
  9. M

    1999 Vortec 7400 injector swap

    i was going to get a tune from Black Bear Performance. I will tell him my problem. Hopfully he can get it to work. I really dont feel like changing them again lol
  10. M

    1999 Vortec 7400 injector swap

    i upgraded the injectors on my 1999 GMC 7.4 from the factory one to the ls1 injectors. Truck runs good now. but I now have a SES light on. I have a p0172-p0175. Both rich codes. I assume its because I have bigged injectors. I was under the impression from all that I read here that it...
  11. M

    1999 Vortec 454 Rough idle

    Going to pull it apart tonight to check. Along with du checking my other work. Maybe I missed something.
  12. M

    1999 Vortec 454 Rough idle

    I wish I checked the dam distributor when I had everything apart. I keep reading the gears are know to go bad.
  13. M

    1999 Vortec 454 Rough idle

    Also it had the factory injectors in it. I was told they were changed by the previous owner but they were pretty rusty so I have my doubts. I also changed the O2 sensor on bank one. I had a lean code bank 1 sensor1. I put the O2 in and did the tune up along with the injections and the FPR...
  14. M

    1999 Vortec 454 Rough idle

    My truck has 92,000 miles. And sorry its not my Tahoe. Its my 1999 K2500 CCSB. Its starts right up most times. Had a couple hard starts with some backfires out the exhaust. Today took it for the first drive in about 2 months. Now it spits and sputters under load. Pops and backfires as...
  15. M

    1999 Vortec 454 Rough idle

    Having a hell of a time figuring this out. My truck has had this rough idle since I bought it. It idles rough and stumbles until it gets about 1500-2000 rpm. No engine codes are stored. It did have a hard time starting and backfired a little a few times but it hasnt done that again. It...
See more

Latest posts

Staff online

Members online

Total: 1,438 (members: 39, guests: 1,399)

Forum statistics

Threads
64,393
Messages
1,393,058
Members
51,570
Latest member
Jefferson Annabel

Share this page

Top