Recent content by malones99
-
M
Lights flickering
Sorry guys, yes sub as in Suburban, I have recently changed the alternator, didn't fix it. I will check all the grounds.- malones99
- Post #9
- Forum: 96+ Vortec Performance + Computer Swaps
-
M
Lights flickering
What do you mean by Amp?- malones99
- Post #3
- Forum: 96+ Vortec Performance + Computer Swaps
-
M
Lights flickering
I have a 99 Suburban Vortec 350. When the the Sub is on the lights flicker. Is it in a rhythm low - high, all lights, headlights, interior, exterior, dash, only when the engine is on. Any thoughts?- malones99
- Thread
- Replies: 9
- Forum: 96+ Vortec Performance + Computer Swaps
-
M
No front drive shaft, possible?
Hi Guys, Im trying to narrow down a vibration in the front drive train. I have a 99 Sub, with the 4 button Transfer Case. Is it possible to drive the Sub with no front driveshaft?- malones99
- Thread
- Replies: 7
- Forum: Axles + Brakes
-
M
HELP! Leaking Diff Cover
Black RTV... is there a special kind? Brand?- malones99
- Post #6
- Forum: Axles + Brakes
-
M
HELP! Leaking Diff Cover
So I have a 10 bolt, I changed the gear oil, and I cannot get the darn thing to stop leaking. Guy at local parts store told ne to use RTV on the cover - to - gasket, gasket to housing, NO RTV between gasket - to - housing. Any All-Knowing GMT Gods please help. I use a felpro gasket and blue...- malones99
- Thread
- Replies: 7
- Forum: Axles + Brakes
-
M
1995 Suburban 2500 ABS question
So I have a 99 ODB2 suburban, any way to get the ABS light to blink?- malones99
- Post #10
- Forum: Axles + Brakes
-
M
1995 Suburban 2500 ABS question
You mention to jump the wires on the ALDL, what is the ALDL?- malones99
- Post #7
- Forum: Axles + Brakes
-
M
Front CV Alxe tight after torque
Hi Guys, I replaced my fron CV axle, seal, and upper and lower ball joints. I have tightened the CV nut to the 165 lbs spec, not the hub is VERY tight, I can hardly turn by hand. Is this normal?- malones99
- Thread
- Replies: 6
- Forum: Axles + Brakes
-
M
99 Suburban NP246
I have a 99 1/2 ton Suburban with a NP246. When in park and T-case in 2hi, engine off, i can turn the front drive shaft a little bit, and can hear it click in the t case. I have checked the u joints and they seam fine. Is this normal?- malones99
- Thread
- Replies: 0
- Forum: Transfer Cases
-
M
99 Suburban 1500 4X4
Is the caliper better, even if use 1500 pads?- malones99
- Post #5
- Forum: Axles + Brakes
