Recent content by kcb905

Upper Control Dimensions

This is exactly what I needed.. If I'm seeing things right you're measuring to the front bushing and these are a full inch shorter than what I've got on my truck. Big thanks!
- kcb905
- Post #7
- Oct 13, 2023
- Forum: Stock Suspension + Bolt On Kits
Upper Control Dimensions

I have a positive camber of about 1 degree on 24x9 wheels. (Tires are low profile) The eccentrics are adjusted inboard as far as they will go (yes, the knockouts are removed) My ball joint angles are good, and the lower control arm is almost parallel with the ground. I have stock springs and...
- kcb905
- Post #4
- Oct 6, 2023
- Forum: Stock Suspension + Bolt On Kits
Upper Control Dimensions

I'm looking for the distance from the bushing center line to the ball joint stud on 2wd. stock upper control arms. If anyone can provide that measurement it would be greatly appreciated.
- kcb905
- Thread
- Oct 6, 2023
- Replies: 6
- Forum: Stock Suspension + Bolt On Kits
Speedo Doing 40MPH In Park.

Thanks, I'm going to dig around under there. Seen a few mentions of that spot before.
- kcb905
- Post #6
- Jun 12, 2023
- Forum: Audio + Electronics
Speedo Doing 40MPH In Park.

That's interesting. Thank you. Could it be tied into the ignition switch cylinder? I really have to force the key to get this thing to turn over and it doesn't always catch. (Waiting on a replacement in the mail at the moment)
- kcb905
- Post #3
- Jun 11, 2023
- Forum: Audio + Electronics
Speedo Doing 40MPH In Park.

Have a 94' with a 5.7ltr. Went out and started the tuck after a week of sitting and noticed the speedo doing 20 to 40mph at idle, in park. (No previous problems) I didn't touch the gas but, the speedo gains/loses MPH if I increase/decrease the speed of the heater blower. What gives?
- kcb905
- Thread
- Jun 10, 2023
- Replies: 5
- Forum: Audio + Electronics
Stock Coil Springs Chevy VS. GMC

Thanks guy, all helpful stuff. Cheers
- kcb905
- Post #6
- Aug 20, 2021
- Forum: Stock Suspension + Bolt On Kits
Stock Coil Springs Chevy VS. GMC

I've got a '94 2wd Silverado currently with old Fabtec 2" lift springs. I'm looking to put stock springs back in it and am wongering if the C1500 springs a cross compatible with the 1500 GMC springs. Did they use all the same springs in the Suburban and Yukon also? Locally at the parts store...
- kcb905
- Thread
- Aug 20, 2021
- Replies: 5
- Forum: Stock Suspension + Bolt On Kits