A cheap Pioneer from Crutchfield; not Walmart. It comes with all the installation stuff you need and I think they have free 3 day shipping going on right now.
Out of all the stereos I've had and installed in mine and other's vehicles, Pioneer has been the best in almost every aspect.
What about Stock Interiors? They seem to have a good rep and have plenty of colors, including dark grey.
You can even get like 5 or 6 free samples sent to you to make sure you're getting the right color.
http://www.stockinteriors.com/AutoCarpet.asp?Itemid=382&MakeId=31&ModelId=88
I would look into the EVO sensor. They can malfunction and cause you to jerk the wheel on small turns. It's located on the steering shaft under the dash. I've heard people just unplug it and forget about it.
Got the RC truck mostly done, not sure what I'm gonna do about the body
Hey man, nobody who's used Creo before is judging you :lol:
I've been using it lately just so I can say I know how to use it. It's similar to SW but nowhere near as intuitive. I like those steps so far though!
It's the same lift. The 6" just has $20 AALs. Buy the 6". Don't put in the AALs, see how you like it, put in the AALs if it's too low.
But ya, 6" is a bit much for 33s
Got bored and made a couple wheels:
The beginning of an RC truck, may or may not 3D print some of it:
Speaking of 3D printing: If you would like something 3D printed, check out this thread! http://www.gmt400.com/forum/showthread.php?29218-3D-Printing-Thread
Thank you everybody who voted for me! Glad to see a pretty good turn out of both participants and voters after such a long absence of TOTM
Thank you sir! I'll PM you soon; gotta think of a topic we haven't done :lol:
Driver's side rear wheel bearings are going. I have a 10 bolt with 8.5" ring gear, which bearings do I need? Looking at Rock Auto and Orielly's there's two different styles. I would prefer Timken
Also, do I need to pull the axles? If you have a video handy, post it up