Recent content by Jurt

  1. J

    New steering gear issues

    My truck is a 94( I just updated my first post). I don't think it has the evo speed sensor. I just removed the return line off the back of the pump. As the engine was running. And I had nothing coming out of the line. Bad pump? Or maybe the gear box is plugged or something?
  2. J

    New steering gear issues

    Hey So I just replaced my power steering pump, steering gear and lines. On my 94 k1500. I think I bled the system correctly, I had the wheels off the ground and went lock to lock 20 times with the engine off. then again with the engine on. Cap off the pump both times. But when I put the truck...
  3. J

    Wiper Issues

    okay it was grounds all along, i did some further digging and the stud where the cylinder head ground and the frame ground meet had become loose from the firewall, and making a poor ground at times. i wiggled it and had no issues with the wipers. So i found a new spot on the fire wall and...
  4. J

    Wiper Issues

    Okay so i finally got around to going through my grounds and replaced the braided grounds from the cylinder head to firewall, and firewall to frame. The rest of the grounds were good. So after i did that, i tried the wipers. They worked once. I went to try them again and it was just a loud...
  5. J

    Wiper Issues

    Okay thanks! i will take a look at the grounds!
  6. J

    Wiper Issues

    okay so i picked up a new wiper motor, when i plugged it in and tried the wipers it did nothing. I checked my voltage at the motor. With the key turned to accessory i have 12v between white and orange wires, and 7.7 between the white and black. these stayed constant regardless of where the wiper...
  7. J

    Wiper Issues

    Hey I am having some issues with my 1994 1500, after i swapped in a new crate motor my wipers are no longer working. (I am not sure if it is related or not). So any time i try to use any functions of my wipers, i hear a faint buzzing up near my windshield that lasts for about 10 seconds, and...
  8. J

    Gas tanks

    Has anyone found any other options to increase the fuel capacity on a short bed?
  9. J

    New tbi crate motor issues

    I will be doing the big 3 shortly. Is the best way to do it with a sstandard side post battery, just to add the accessory battery terminal posts and run the larger wires off of those? I agree it could have been a lot worse. But I had a helper that I was watching the engine bay. I also keep a...
  10. J

    New tbi crate motor issues

    well i fixed the battery ground and replaced the braided ground. Fired up and was able to time it! Thanks!
  11. J

    New tbi crate motor issues

    You are 100% correct. My cable is bolted to my frame. I had a friend help me putting the truck back together, and I wasn't paying attention to where he put it. I'll have to get a new ground strap and move the battery ground to the block. Any idea if this would have wrecked anything else? Or...
  12. J

    New tbi crate motor issues

    Well it wasn't cranking normally. It was as if it straining to start it and then stalling or locking up the starter. Could that all be from a loose connection? I will take a look and see what I can find. Thanks.
  13. J

    New tbi crate motor issues

    Hey guys. I just finished swapping a new gm tbi crate motor into my 1994 k1500. I put an rv cam, lifters, roller rockers and a performer intake. I roughly set the timing to 0 degrees at tdc and disconnected the timing advance wire, I just fired it up to perform the break in process of the...
  14. J

    Auxiliary Engine Oil Cooler

    Hey check out this link http://www.gmt400.com/forum/showthread.php?947-Engine-Oil-Cooler-Upgrade-Add-2-quarts!-(SAS-guys-you-ll-want-to-see-this) I did the exact same, it works great!
Top