Recent content by Hyperti2

  1. H

    98 K1500 L31-R LONG BLOCK QUESTION

    Put the 4bolt main in my 98 1/2 ton bolted right in 30k later it still runs great. Sent from my SM-G900V using Tapatalk
  2. H

    My Final Upgrades ....pushing the limit

    How did you get the frame that clean!?
  3. H

    LMC Doors

    Has anyone on here used LMC Full door shells? I need a set of doors for the truck I'm building and was wondering if they were of good quality or not. Rust free doors are hard to come by up here in New England. Thoughts?
  4. H

    Hinge Assembly Replacement

    Man alot of work couldn't you just weld the elongated side of the hole and run a drill bit through it?
  5. H

    Vortec fuel Pumps

    Outside of the tank prob 6inches of lead down soldered and heatshrink
  6. H

    Vortec fuel Pumps

    When I put my previous fuel pump in I had to solder in a different connector not sure if that is still an issue.
  7. H

    Vortec fuel Pumps

    I need to go to the store tomorrow and find out
  8. H

    Vortec fuel Pumps

    So in may of last year I put in a new acdelco fuel pump and a new gas tank. and now it's time to do it again 11 months later. Pump is noisy and I only have 50psi of pressure. I'm definitely not very interested in another Delco pump so what do you guys recommend? Thanks guys.
  9. H

    Removing Window Regulator

    Just finished the swap my parts truck had the window all the way up just had a buddy make sure the window didn't slam down when I pulled the last roller out. Other than that went exactly how the video shows
  10. H

    New from massachusetts.

    Welcome I'm from mass also
  11. H

    Removing Window Regulator

    I'll see how it goes thanks guys
  12. H

    Removing Window Regulator

    So I did a quick search about removing the regulator and it seems straight forward however everyone says to completely lower the window. The regulator in my truck managed to bend itself and will not let my window fully go down and I'm afraid of it breaking the window. So if I have someone hold...
  13. H

    what all to replace/Any good upgrades to install when replacing a Vortec?

    I did my automatic transmission lines and painted my frame while in there
  14. H

    Air Bags

    Pulled the module out. Plug was a little tricky at first but got it out. I think I have all the pieces now. Crash monitoring sensor in the front bolted to rad support both airbags and air bag module. Time to pull my truck apart
  15. H

    Air Bags

    Alright thanks a ton Richard I'll let you know
See more

Latest posts

Members online

Total: 1,158 (members: 15, guests: 1,143)

Forum statistics

Threads
64,776
Messages
1,400,325
Members
52,417
Latest member
Dman

Share this page

Top