Recent content by chevyguy28

  1. C

    Rumble rumble

    those couple of inchs of turndowns really make that much of a difference huh? i guess ill have to take mine off then...
  2. C

    still getting from end play after all new parts were installed??? any ideas

    Don't mean to thread jack but how do you tighten up the gearbox, have a little slop in mine.
  3. C

    Rumble rumble

    i've got gibson shorties, true duals, no cats and 31in cherry bomb glass packs dumped before rear axle. Don't sound bad at cruising or takeoff but anything more than 3 grand and it sounds like sh*t. especially at WOT.
  4. C

    Sorenson vortec MPFI Conversion spider assembly

    I got a dumb question.....how do you know when the spider unit is going or gone?
  5. C

    JUmpy Gauge Needles

    The truck is a 97, only the gas gauge does it. where is the stepper motor located and what does it look like?
  6. C

    JUmpy Gauge Needles

    Stepper motor huh? Easy fix?
  7. C

    JUmpy Gauge Needles

    Not to high jack, but I';m haveing the same problem too. Gas gauge gets jumpy and at times will do 360's and hit the oil press gauge. Replaced the sending unit and it still does it, what else to check/replace?
See more

Latest posts

Staff online

Members online

... and 7 more.
Total: 1,147 (members: 57, guests: 1,090)

Forum statistics

Threads
64,738
Messages
1,399,661
Members
52,324
Latest member
Uncle Jeff

Share this page

Top