Recent content by badassformula383lt1

  1. B

    suspension question

    i had it aligned a few weeks back it was a basic alignment. They made no comments about the front wheels folding in when turning. If i turn left the top of the left wheel folds out leaving about a inch of the outside tire left on the pavement if i turn right the right the right top of the tire...
  2. B

    suspension question

    Haven't been on the computer in a while do to work and stuff, but since i started this thread ive replaced... the upper ball joints, lower ball joints, both cv axles both front hubs and both tie rod ends. The only thing i haven't replaced is the upper control arm bushings and lower control arm...
  3. B

    suspension question

    nobody has any info on this?
  4. B

    suspension question

    Hey i replaced my upper ball joints 2nd time now went with moog parts this time lol. I also replaced my right side tie rod end and finally installed my sway bar. Previous owner left it loose un attached. Well after all that it looks as if it has toe in and the front end sits like its binding up...
  5. B

    Motor swap question

    i really would like to go diesel i was just offered the 6.5 swap for 500$ was ready to jump on it being that's less then it would cost to rebuild my 355. If the 4l60e bolts up to a 6.5 then wouldn't my built th350? I was really wanting to go diesel for the torque the 355 has nice heads cam long...
  6. B

    Motor swap question

    I have a 1995 silverado z71 4x4 mods are in my sig. Im currently running a 355/th350 trans with a carb motor an is in need of a rebuild low compression on one cyl. I recently found a 6.5 turbo diesel swap with 211K miles complete with harness and ecm and all needed for the engine for pennys...
  7. B

    1995 carb question

    Ive been going through the truck i recently bought. Since then ive replaced a lot, currently it has a 355 with a cam fuel system consisted of a stock in tank pump leading to a small filter connected to a cheap external fuel pump then going into the stock fuel filter then to a return regulator...
  8. B

    transfer case question

    Im doing a trans swap on my 95 silverado z71 it already had a trans swap but i fried the th350 so had it rebuilt. Upon removal i noticed gear oil pouring out of the tail shaft of the transfer case. Last time i checked it took ATF fluid not gear oil. Transfer case worked fine but now i need to...
  9. B

    New from SW FL

    thanks everyone, im from the north port, port charlotte area of florida. Right around where red neck yacht club takes place truck will be there for the trucks gone wild event.
  10. B

    New from SW FL

    Heres my old post. thanks guys. Hey figured i would re introduce myself. Im back into a 1995 z71 ext cab after selling my old 1995 k1500 SCSB 4x4 a few years ago. Traded my Trans Am 383 forged motor 6 speed for the Truck. It needs some work but oh well its gonna be a big project. Its currently...
  11. B

    New from SW FL

    Here are a few pics i said id get of the new truck. The TH350 went out wont shift anymore so its down till i can get it done so i cant get it to a car wash to get it all cleaned up.
  12. B

    Th400 np 241 question

    found out the front gears "should be" 373s being its a GT4 rpo code in glove box. so just going to try to find a 14 bolt with a 373 or swap the gears out.
  13. B

    Th400 np 241 question

    well got the 4wd to lock in and work. But the gears in the back do not match the front. Locked it in 4low and started moving an the front end wanted to walk all over and was hard to move. Pulled it out and went home. Now need to figure out what gears and in the front and what ones are in the...
  14. B

    Th400 np 241 question

    Ok since its been switched to a th400 ill do that
  15. B

    Th400 np 241 question

    Thank you ill replace it tomorrow if the part store has it.
See more

Latest posts

Members online

Total: 1,000 (members: 23, guests: 977)

Forum statistics

Threads
64,517
Messages
1,395,691
Members
51,883
Latest member
wjauto1777

Share this page

Top