I've done djm 2inch drop spindles w/ 1 inch crown springs, djm flip kit with the adjustable pinion and kyb shocks on all four corners. Belltech front sway bar, handles nice just wish I didn't do djm flip kit , will probly change it out soon.
Brakes I did sbcc big bite rotors and ceramic pads...
I'm sure it will need a tune eventually. The kit says it needs 50 to 65 psi of fuel pressure is the only reason I'm thinking that. Now that I'm at around 15-20 psi it runs idles fine, just drove around the block.
The ProcHarger kit says it needs 50psi of fuel , the kit came with a external pump to run with stock pump. Also I got it all running but I'm only at around 20psi of fuel pressure right now. My injector pod holder was leaking alot of fuel so it was flooding the motor. I think I warped it with my...
I installed a procharger and extra fuel pump to get fuel pressure up to 50psi. And my throttle body leaks fuel where the shaft goes into throttle body to open flanges . Any help would be great? I've replaced the throttle body once cuz I warped it doing tbi mods. It's a 93 Chevy 5.7 around 175k...
I've seen pics its a 5 lug and so is my 93. Weather or not the rear end is out of a 2000 Silverado I dont know, that's what the guy says its out of who's selling it
Hi I have a 93 Chevy c1500 2wd, I wanna know if a 2000 Silverado rearend will bolt right
Up? I found one with 373 and posi. Since my rear end has 300k miles on it. Not gonna last
Much longer
I'm dealing with same situation, I lowered my truck 3/6 kit and the procharger intercooler sits too low under neeth for me so I'm gna mount behind the grill, but gna have to remove the support brace