MrPink
Bainisteoir Páirteanna
No the harness that was on the TBI that passed through the firewall and connected to the ECM, I/P and something else. And then the big connector by the Booster on the firewall
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
I kept everything related to the factory fuse block and cut basically the entire engine harness out of it, kept the starter signal, a/c wiring, and a few other things. LS is on a standalone, I think I had to do more to wire my gauges than to power the engine harness.No the harness that was on the TBI that passed through the firewall and connected to the ECM, I/P and something else. And then the big connector by the Booster on the firewall
Bought an ebay tubing kit, no pipe bender. First time building an exhaust so there are a few improvements to make .Truck sounds good, but wtf is wrong with that y-pipe. It looks like it hangs super low.
Bought an ebay tubing kit, no pipe bender. First time building an exhaust so there are a few improvements to make .
I'll look into it, appreciate it. The front crossover will get redone soon one way or the other. Need to pull 3" or so in-between the bends and it'll be a lot better.Check out the Jegs "offroad" y pipes. Man they fit great. I used one on the Suburban I swapped.