So I worked on my Denali cluster today. I need to re cal the gauge needles. I also went through the air stepper motors. The fuel motor is wired different than any of the other motors are. It is the only motor with 1 wire on 2 of the legs, , and 2 wires on 1 of the other legs. Than means there is 1 leg with no wire on it at all. All of the other motor have 1 wire per leg. By leg, I am talking about the 4 prongs that stick out of the back of the motors, and make contact to the cluster housing. So long story short, No you can not simply swap the resistors around. The motors are not interchangeable.