TruckinAin4Sissies
L.E.D. Whisperer
It's always worked for me, not sure what you did wrong.I did this and they fob never worked again. did I do something wrong
Sent from my SM-G935V using Tapatalk
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
It's always worked for me, not sure what you did wrong.I did this and they fob never worked again. did I do something wrong
This did not lengthen the reach of my fobs signalHere's how I increased the signal from my Keyless entry remote 7x!
I could only lock/unlock my truck from ~5 feet. Now I can do it from 35 feet away.
Items needed:
Soldering iron
Solder
~4" wire
Here's the average distance for the factory remote (in my case).
You must be registered for see images attach
The FCC has a maximum signal output that the manufacture must abide buy. Well, like Bieber F 'em!
You must be registered for see images attach
Process:
Use a flat screwdriver to separate the two halves of the remote
You must be registered for see images attach
The 2 halves & the buttons were little dirty.... Clean 'em up.
You must be registered for see images attach
You must be registered for see images attach
Grab your Soldering iron, solder & a short piece of wire.
You must be registered for see images attach
Solder the wire to the area pictured.
You must be registered for see images attach
Route the wire like this.
You must be registered for see images attach
Put the two halves back together and test it out.
Any questions?
Then you did it wrong.This did not lengthen the reach of my fobs signal
I soldered a piece of wire to the right placeThen you did it wrong.
Sent from my Pixel 2 XL using Tapatalk
Post a pictureI soldered a piece of wire to the right place
My solder didn’t hold, guess it’s too cheap. anything else I can use to hold it in place?Post a picture
Sent from my Pixel 2 XL using Tapatalk
My solder didn’t hold, guess it’s too cheap. anything else I can use to hold it in place?
I can’t get it to melt around the wire. All it does it melt off the stick into a hard little ballA not cold solder joint should do nicely.
I can’t get it to melt around the wire. All it does it melt off the stick into a hard little ball