Cheyenee35
Newbie
Thanks sewlow. I spent a lot of time in the seat forum threads. IIRC you are the upholstery guy that gave a ton of good advice on seats/interiors.
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
IIRC, GM welded the nuts on the bottom for the front.Question for those of you with a factory installed center console. For the front mounting bolts, did the factory use weld nuts under the transmission tunnel? For now my front bolts are merely threaded into the floor with factory 6mm bolts. I can purchase some nuts to run on there but want to follow the factory. Wondering if they used weld nuts or perhaps a bracket under the floor to properly capture the bolts.
No, I have not. But if you tackle it, consider doing a write-up with pics for the forum. I for one would be interested in how you go about it and the results. Just this past winter mine finally cracked, began to fail. Right in front of the driver, just out of sight. I didn't notice until I was cleaning the dash one day. Looks terrible.
I understand it is a chore to remove/replace it.