RCSB_jonny
OBS Enthusiast
As far as I know, it's original
Would you happen to have the paint code or RPO for it?
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
As far as I know, it's original
It wasn't too hard to put in seats from a 2018 Silverado. Plus, was good to add a phone charger to the center console.
Awesome job man. In fact I didnt BUY my 2017 seats until after i read your post! Can you clarify thr kump seat mounting for me? I woukd rwally appreciate any help man. Also which color wires did you use to power the USB and outler adapter? Did you get the AUXjack working? Thanks manThe width of the seats including the jump seat is 57 inches, same as the bench seat that came with the truck. The rails on the new seas are wider and they also had hooks and nipples i cut off with a cutting wheel and then used an angle grinder to smooth everything out.
You must be registered for see images attach
My goal was to use all the existing holes if I could. I welded two 3/16 in thick steel bars on the seats and sat them back in the truck and marked where the holes would be by shooting up the holes with spray paint. Since the passenger side only had two holes because there was a bench seat, after I marked the two holes and drilled them i measured out 10 inches for the other two holes I had to drill because there was clearance underneath at that point. I utilized m10 1.5 60mm bolts.
You must be registered for see images attach
As for the jump seat. I used one of the existing holes that held he bench seat closest to the driver and welded a 6" piece of steel to the bottom of the jump seat and bolted it down from the rear. I then used two #14 2 inch slef tapping sheet metal screws on each side to hold it in place.
You must be registered for see images attach
You must be registered for see images attach
Awesome job man. In fact I didnt BUY my 2017 seats until after i read your post! Can you clarify thr kump seat mounting for me? I woukd rwally appreciate any help man. Also which color wires did you use to power the USB and outler adapter? Did you get the AUXjack working? Thanks man
Where did you get these from??Rear lights were pretty faded and was just going to replace bulbs with LEDs. Ran across these lights and figured why not.
Wasn't sure how I felt until the evening and thought they looked pretty good. Reverse light is much brighter than stock for sure.
You must be registered for see images attachYou must be registered for see images attachYou must be registered for see images attachYou must be registered for see images attachYou must be registered for see images attach
EbayWhere did you get these from??
Thanks for the link! Truck looks great btw, i love it.