Forced to display my ignorance about re-programing/flashing!
My goals for the Snap-on MT2500 "community scanner" include:
Re-calibration of the speedometer.
Increase the torque converter lockup pressure a little.
Disable the EGR by increasing the temp it operates at.
Ignoring the second oxygen sensor.
Disable the speed limiter.
I can't figure out how to do any of that with the red brick! Hope I am just doing something stupid.
Do I need a laptop with more programs and an interface cable to do this?
Is there another menu selection I need to find on the MT2500?
Thanks for the help.