knucklebuster283
Newbie
- Joined
- Jan 2, 2015
- Messages
- 12
- Reaction score
- 0
After some lookin around this forum, I may have created my own nightmare. I just picked up a 90 W/T 1500 2wd. with no brakes at all. So I what I've done so far,new calipers+ pads, all 3 hoses, one new wheel cylinder, new vac booster and 2 mc's, deleted the rwal. I have blown out the lines with air before installing the mc, and have gone through 1.5 gals of brake fluid trying to bleed the brakes. The fronts have bled but are locking up when I bleed the rears, and am hardly getting any fluid to the rears. First mc was a reman from AZ which I've taken back and purchased a new mc from orielys. So I'm wondering if I may be pushing the piston too far in when bench bleeding the mc, the reason I'm not getting good fluid flow to the rears? Just to claireify the front bleeding first is because I at first just did the fronts then found the passenger side wheel cylinder leaking.