I think I am just going to put a reman engine in, and add an upgraded intake manifold, headers and the plug and play electronic fuel injection system(MPI).
“Fraisers Engines,
The base engine consists of:
•A cast-iron engine block and cylinder head
•Overhead Valve (OHV) design
•Hydraulic roller camshaft
The engine specifications include:
- A displacement of 350 cubic inches (5.7 liters)
- 4.00 in x 3.48 in (101.6 mm x 88.4 mm) cylinder bore and piston stroke
- 8.5:1, 9.2:1, or 9.5:1 compression ratio
- 190 to 330 horsepower (142 to 246 kW) at 4,000 to 5,200 rpm
- 300 to 380 lb-ft (407 to 515 Nm) of torque at 2,400 to 4,000 rpm”
So asking everyone now lol, does this sound correct from the replies, or am I missing anything or misunderstanding anything??
In addition, should I flush and replace fluid in all systems and as far as sensors and wire connectors and other electrical components go?
What can I reuse and transfer, what should I replace and what should I be wary of/pay close attention to in addition?