98chevy2500SS
Specializes in Accessories 101
x2 on soap and water test.
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
What kind of leak detector would i need to get?
Ready to see this!!After sitting idle on this project and getting some customer projects done, (667 wheel hp 87 firebird was a fun one) i ordered the last of the **** i need for my blower intake build. I am totally changing directions on how i was doing it. I am making a long runner intake that the blower will bolt to. Be a simple unit when its done but i have collected all the stuff i need 20' stick of 1.25x3" rectangle 1/8" aluminum. Two flat stock 1/2 thick pieces for mounting flange. New bits to mill orings into the top for sealing. 102mm throttle body. 4" elbow to move the tb out. Tb mount flange. Injector bungs. Some aluminum to make an intercooler ice tank. Also my motor donor vechicle was a suburban with rear air. Im going to use the dual ac system and mount one cooler in the tank, submerged in water to drop my intercooler temps well below ambient. Ill have a big enough reservoir that ill have more than enough cold water for long wot pulls. I plan on running enough boost to get me into 500wheel hp.You must be registered for see images attach
You must be registered for see images attachYou must be registered for see images attachYou must be registered for see images attachYou must be registered for see images attachYou must be registered for see images attach
Depends on who you ask. Im modifying alot on this. Bigger inlet. Ported the inlet to the rotors, factory has a 80mm tb. Im putting a 4" 90* elbow on the back and mounting a 102mm on the side like a gt500 setup.Were you supposed to cut those? Lol