1988 GMC C1500 - Z06 Package!

[Supercharged111]

I have the factory gas box but it has that lame elbow. I'd thought about doing a Volant box but this would be much cheaper if I can find one.

 

[0xDEADBEEF]

$125 is less than I've spent on various cold air intake stuff over the years trying to find something decent for my 5.3. I think I'm going to get one!

 

[PolarBear]

$125 is less than I've spent on various cold air intake stuff over the years trying to find something decent for my 5.3. I think I'm going to get one!

So, my cost on this adventure is around $110.

Used an Amazon 99-06 4" "Cold air intake" kit, 6.5 TD airbox, 1/2" wide 304 SS clamps to replace what was in the amazon kit, 4" x 12" silicone coupler, new filter element for the 6.5 TD airbox.

 

[0xDEADBEEF]

So, my cost on this adventure is around $110.

Used an Amazon 99-06 4" "Cold air intake" kit, 6.5 TD airbox, 1/2" wide 304 SS clamps to replace what was in the amazon kit, 4" x 12" silicone coupler, new filter element for the 6.5 TD airbox.

Are you going to run a MAF sensor? I didn't see one.

 

[PolarBear]

Are you going to run a MAF sensor? I didn't see one.

I'm not, speed density is the ticket for me.

Aaahhh, the days of having a life of leisure are here!

Not only was I driven to the shop, also have my media blasting handled.

Guess I'll just recline back and watch!

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

 

[Supercharged111]

You should tell her to pull that seat forward.

 

[PolarBear]

You should tell her to pull that seat forward.

I tried! She prefers just standing on one skid.

Just like the phone books on the seat to boost her up as a child. We're figuring out what works for her.

 

[GrimsterGMC]

I'm not, speed density is the ticket for me.

Aaahhh, the days of having a life of leisure are here!

Not only was I driven to the shop, also have my media blasting handled.

Guess I'll just recline back and watch!

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

Mate, you've got a winner there, with a can do attitude like that the world is hers for the taking.

 

[PolarBear]

Mate, you've got a winner there, with a can do attitude like that the world is hers for the taking.

I constantly preach to her, she can do anything a boy can. It's just finally sticking with her.

 

[PolarBear]

Had a few minutes while parking cars in my shop in order to avoid the forceasted hail, to stop and pull the dash out, that way I can go through the HVAC box, get it cleaned and new heater core, evaporator core and blower motor installed!

Tried to bleed the clutch system again on this 5LM60, I'm highly unimpressed with the slave. Starting to think I may have a defective new slave cylinder. Flow is good, no air in the system, it just won't extend far enough to press the clutch fork.

I really think I'm going to start looking for a TH400.

You must be registered for see images attach