“Hard Life”

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

sarnold75

Newbie
Joined
Apr 2, 2020
Messages
16
Reaction score
19
Location
Rayland, OH
As old77 put it in on my initial post will be the working name of this truck. New bushings installed. Ran into a couple surprises!!! Both passenger corners were pressed through. Luckily I did some reading and got some xxxl washers from local equipment company. Used a couple on frame brackets where oe bushing was pressed/rusted through. Corners massaged metal back down and sandwiched top and bottom. Should hold until I can get substantial bracing fabled in.

You must be registered for see images attach


You must be registered for see images attach


You must be registered for see images attach


You must be registered for see images attach
 

sarnold75

Newbie
Joined
Apr 2, 2020
Messages
16
Reaction score
19
Location
Rayland, OH
A couple after.

You must be registered for see images attach


You must be registered for see images attach


You must be registered for see images attach


You must be registered for see images attach
 

Suburban1500

I'm Awesome
Joined
Apr 24, 2013
Messages
811
Reaction score
977
Location
Tucson
I like the roll bar, looks great! Been thinking of getting one for my long bed.
 

sarnold75

Newbie
Joined
Apr 2, 2020
Messages
16
Reaction score
19
Location
Rayland, OH
Found these at Tractor Supply, thinking for the roll bar. Has three mounting points prefabed in.
You must be registered for see images attach
 

sarnold75

Newbie
Joined
Apr 2, 2020
Messages
16
Reaction score
19
Location
Rayland, OH
New headlight assembly’s came in today now waiting on all the led’s to show up. Stopped by tire place and have appointment for next Thursday. Set of Americus rugged m/t 315/75/16 (35x12.50x26). Wanted wider but would have to get bigger rims and just not ready to drop another grand on wheels.

You must be registered for see images attach
 

sarnold75

Newbie
Joined
Apr 2, 2020
Messages
16
Reaction score
19
Location
Rayland, OH
New housings and corners in. Headlight came with halogen low in projector. Waiting on led signal and markers to show up. Halo rings not as bright as I’d like might be a ground but also going to try to switch wiring around to make the halos DRL and turn off procjectors to just switched. But HUGE improvement over original hazed and cruddy originals!!!

You must be registered for see images attach


You must be registered for see images attach


You must be registered for see images attach
 

sarnold75

Newbie
Joined
Apr 2, 2020
Messages
16
Reaction score
19
Location
Rayland, OH
Here’s a night shot.

You must be registered for see images attach


You must be registered for see images attach


You must be registered for see images attach
 
Top