Search results
-
2
Cannot get doors back on
I took the doors off to paint truck and replace bushings. Replaced bushings and did a test fit with one door (perfect body lines). Now a few weeks later I cannot for the life of me get the doors back on. I keep hitting the fenders or bumps in the hinges. Maybe I have the door to wide open...- 2s9je0af
- Thread
- Replies: 10
- Forum: Paint / Body / Detailing
-
2
Bucket to Bench Bolt Holes/Seatbelts
I have a project truck that came with powered buckets that I don't feel like fixing ATM/am changing paint color. I need to swap my 60/40 bench seat in. I have not seen a good writeup/video for this swap. These trucks don't come to the junkyard often enough for me to measure.... Anybody know how...- 2s9je0af
- Thread
- Replies: 2
- Forum: OEM and Custom Interiors
-
2
OBD1 4L60E Scanning?
I have tunerpro but I don't see a way to read anything other than P,Drive. Is there software that can get at the transmission codes/live data for a 1994 w 4L60E? I can't seem to get 2nd gear (slow or not at all). If I directly shift into 2nd I can get into 2nd immediately. I don't think I have...- 2s9je0af
- Thread
- Replies: 4
- Forum: Transmissions
-
2
What is my engine burning?
1994 K1500 TBI 5.7 170K miles (mud truck since paint failed ~2001, fuel pump died in 2012 sat under oak tree until 2023) I have "white smoke" that comes out of exhaust when idling. Doesn't smell sweet like coolant or dissipate quickly like water vapor (hangs around like oil smoke). The smoke...- 2s9je0af
- Thread
- Replies: 8
- Forum: Engine Performance + Maintenance
-
2
Where to buy R134a temperature switch for pre 94's
Have a 93 suburban that was partially converted to R134a by previous owner but they didn't change dryer or shrader valves (exploded). I don't want to remove the dash. Is there a special R134a pressure cycle switch that threads on an R12 dryer? R134a dryer won't thread on my R12 evaporator. I...- 2s9je0af
- Thread
- Replies: 4
- Forum: Engine Performance + Maintenance
-
2
Did I goof my timing? BLMs 105
Stumbles in parking lot driving slowly after a warm start. RPMs flutter by ~50 RPM when in closed loop. Runs great in closed loop. Heater core hose crumbled and I had to remove intake (and distributor) to extract. I put distributor back exactly in the same position (I think). PO used tap water...- 2s9je0af
- Thread
- Replies: 4
- Forum: Engine Performance + Maintenance
-
2
Rusted Thermostat Repair
K1500 5.7 PO apparently ran tap water in system for 6 months rather than replace blistered heater core hose... :(. Went to change thermostat and found what was left (just the little top "hat" looking part). I guess the rest of the thermostat dissolved? Radiator is pretty orange inside (assuming...- 2s9je0af
- Thread
- Replies: 13
- Forum: Engine Performance + Maintenance
