Search results

  1. S

    15" drag race (looking) wheels for a C1500

    I've been looking all over for a set of reasonably priced 15" drag race (looking) wheels for my C1500. I do not want steel wheels and I do not want to spend the cash on Billet Specialties, Weld Wheels, etc. I've seen a few knock off wheels that I likes, but hard to find them in a 5x5 bolt...
  2. S

    5.7 connecting rods

    Long story short, I have a fresh '98 355 in my '96 c1500 that seems to have a bent rod. She was knocking pretty hard, so I pulled the engine and drained the oil. The oil looked like chocolate milk. I don't know how the engine got water in it, but it was there. The engine is back at the...
  3. S

    fresh vortec engine build won't start

    I dropped a 355 into my 96 c1500. Engine is nearly stock except for a small cam, headers, MSD ignition components, and a computer tune. We didn't know where #1 piston was at on the stroke. So we stuffed a paper towel into the #1 plug hole and turned it over till it blew the towel out. The...
  4. S

    where to buy S10 torque converter

    where is everyone buying their S10 torque converters from?
  5. S

    fender/antenna cable removal

    I am removing the right front fender of my 94 burb. What do I need to do to remove the antenna cable so that I can remove the fender? Does the base itself unscrew from the outside and the cable pulls through the fender?
  6. S

    Weld Mountain Crusher wheels

    I just picked up a set. The tires look good, the wheels look like sh*t! Has anyone been able to remove the allen headed bolts on these wheels to help with clean up?
  7. S

    what rpms is a stock vortec 350 good for?

    What is the rpm range on a stock vortec 350? I know that the black box won't let you go past 6000rpms, but a stock 350 vortec isn't making power up there either. So what kind of rpms would a stock 350 with a 3.42 rear gear be turning cruising along at 30 mph? I'm looking at cams in the...
  8. S

    I think I need to lower my compression

    I am running a 355 with flat tops. This was going into another project that had 76cc heads on it. Now I want to put on a set of reman vortec 350 heads and use it in my '96. Gas in our area is rated at 87, 89 with 10% ethanol blend, and 91. I always run the 89 because it is the cheapest. With...
  9. S

    how's this engine/tranny combo?

    I am doing a 305 to 350 swap in my '96 rcsb. The 350 I am using was going to be a tbi engine, but I am going to do an ls swap instead. So, here is what I have and what I am thinking I want. What I have; fresh 355 flat tops lt1 cam, new lifters, new pushrods (pushrods were meant for a set...

Latest posts

Staff online

Members online

... and 10 more.
Total: 1,661 (members: 60, guests: 1,601)

Forum statistics

Threads
64,394
Messages
1,393,100
Members
51,571
Latest member
chrisislegend01

Share this page

Top