Search results

  1. swervin

    Oil pressure..

    Just finished rebuilding the top end on my 1990 gmc k2500 with a 5.7 tbi, after reassembling almost everything I wanted to make sure I was getting oil everywhere so I removed a valve cover and tried cranking it with the fuel pump relay unplugged and the main spark plug wire to the distributor...
  2. swervin

    How did these end up in there?!?

    I was simply just going to do a fluid flush on my clutch system... or atleast i thought. So first thing that happened was part of my slave cylinder broke off where the bleed screw goes in. I tried to do a temporary fix in an underground parking lot on a rainy night, thought i did a good enough...
  3. swervin

    How did these end up in there?!?

    I was simply just going to do a fluid flush on my clutch system... or atleast i thought. So first thing that happened was part of my slave cylinder broke off where the bleed screw goes in. I tried to do a temporary fix in an underground parking lot on a rainy night, thought i did a good enough...
  4. swervin

    Fuel pump

    Im not getting power to my fuel pump, and after a couple tests i think its my relay. Can i just delete the relay and use a switch? (Probably cheaper considering i have a few switches already) If so what size wire should i run, how many amps should the switch (and probably fuse) be rated for, and...
  5. swervin

    350 tbi high idle? Sticky choke? Constant throttle?

    I have 2 gmc k2500 manual 350 tbi's, both have the same issue. When i start one up after sitting overnight i always let it warm up for atleast a minute befor driving (usually longer). When it first fires up its at a fairly high rev, after about a minute it calms down a bit. But it will stay like...
  6. swervin

    1990 350 tbi, 1997 305 vortec

    I just got a good deal on a 1988 eclb light duty 2500 4x4 maunual trans with a 350 tbi, i also have a 1990 thats identical other then its rclb which im restoring a bit right now, then my dad says he found a cheap auto 2 wheel 1997 with a vortec 305. I was wondering if i could switch heads and...
  7. swervin

    frame mounts or brackets..

    Just wondering if anyone knows if frame mounts are sold anywhere. The bump stop for my lca rotted out as well as the rad support mount and probably more.. They are welded on from factory, so im guessing no ones going to promote hacking away at your frame with an angle grinder, chisel, and a...
  8. swervin

    stuck torsion bar

    Im doing a partial front end resto on my 1990 k2500, but cant get the torsion bar, torsion key or lower control arm off. Ive tried pb, wd40, no name penatrating lubes, rust evaporaters, just about everything i could think of atleast 3 times each, and tried to beat on the torsion bar from the...

Latest posts

Members online

... and 34 more.
Total: 1,729 (members: 84, guests: 1,645)

Forum statistics

Threads
64,425
Messages
1,393,809
Members
51,633
Latest member
95bigbertha

Share this page

Top