Search results
-
S
Blower motor recommendations?
Last year I replaced my falling blower motor with a 4Seasons brand. Very little air flow. So, going to swap it out again. Any recommendations on brand and where to order it from? Thanks.- Stewart Harrison
- Thread
- Replies: 11
- Forum: Audio + Electronics
-
S
Putting newly rebuilt trans back in, can't find wire
Ok, so for the past few months I've been rebuilding my 4L60E in my 1999 GMC Suburban C1500 2wd with a 5.7 Vortec. I'm finally done, took so long b/c I didn't know what all parts I would need at first and had family and job responsibilities. Rebuild is finally done, putting the transmission...- Stewart Harrison
- Thread
- Replies: 3
- Forum: Transmissions
-
S
Alto 3-4 clutch powerpack transmission rebuild
My 4L60E in my 1999 Suburban with a 5.7 Vortec engine went out recently. The transmission is the 96-99 model with the detachable bellhousing, but not the deeper one that was put on 2000 models, but has a deep pan filter. I bought a rebuild kit on ebay that has the Alto 3-4 clutch powerpack...- Stewart Harrison
- Thread
- Replies: 2
- Forum: Transmissions
-
S
1999 GMC C1500 Suburban 4L60E going bad (3-4 slipping)
Sorry for the newbie question. My 1999 GMC C1500 Suburban 2wd started slipping the other day. It shifts from 1-2 fine, sometimes slips from 2-3 and all the time from 3-4, or sometimes won't go into 4. I want to pick up a used transmission from a Pull-A-Part soon and replace what I have, then...- Stewart Harrison
- Thread
- Replies: 0
- Forum: Transmissions
-
S
Blower motor screw broke
Have a 99 Suburban C1500. Was replacing the front blower motor and broke one of the 7/32 head screws and bent two more dangit. So I have two good screws left. Having a hard time finding replacement ones online. And any advice on how to remove the half of the broken screw from the plastic...- Stewart Harrison
- Thread
- Replies: 0
- Forum: Audio + Electronics
-
S
Blower motor screw broke - ignore, reposted in the correct area
Have a 99 Suburban C1500. Was replacing the front blower motor and broke one of the 7/32 head screws and bent two more dangit. So I have two good screws left. Having a hard time finding replacement ones online. And any advice on how to remove the half of the broken screw from the plastic...- Stewart Harrison
- Thread
- Replies: 2
- Forum: The Garage
