Well the motor isnt and/or hasnt knocked at all so i dont think its a main bearing failure. i believe its a sender unit. the low pressure happened after i mixed the 5w20 with the 5w30
Yea i hopped it was a sensor screwed up. this is the second motor the trucks had and it has 200k on it. if this one blows im gonna buy a brand new long block. ill have to hook up a mechanical gauge and see. hopefully its just the sending unit
Hey, when i accelerate from a dead stop or do a burnout, my oil pressure gauge drops to zero then comes back up. engine sounds fine when the gauge reads zero. And also my oil pressure is reading lower than usual. at idle is reads normal. cruising at 50 mph it reads about 30-38 psi when usually...
My 5.7 vortec randomly died going 45 down the road while i was driving. anybody know what would cause it? no CEC and no codes. had to use my jumper pack to start it again after i pulled over
Does anyone know where i could get some new corner light nuts? when i removed my old ones the threads on the nuts were so thin the bent and idk if theyre still usable.