Recent content by Old Goat Ninja
-
A Lil help
And, just pointing out the obvious, only half the difference in tire size. If new tire is 2" taller (say a 31" vs a 33"), only 1" of that is raising anything.- Old Goat Ninja
- Post #25
- Forum: Stock Suspension + Bolt On Kits
-
I sand down my wheel's outer lips?
Keep it black. Getting a nice clean line would be hard, and then touch ups on the line afterwards would suck, etc.- Old Goat Ninja
- Post #4
- Forum: Paint / Body / Detailing
-
RF sticks
Yup. I'll change calipers and lines this weekend. Thanks guys. As a side note, my old neighbor just happened to drop by and saw truck for the first time. He crawled all around it checking it all out and said it's a solid truck, nothing major wrong with it. We're going to fix a few other things...- Old Goat Ninja
- Post #8
- Forum: Axles + Brakes
-
RF sticks
Yeah, I don't want to change pads now, just because I did a couple days ago. I changed pads and rotors. I'll go ahead and do calipers and lines next. My local O'Reillys has the Calipers for $16 so cost isn't bad at all. Hoping this will finally get rid of this problem. It should, not much left...- Old Goat Ninja
- Post #5
- Forum: Axles + Brakes
-
RF sticks
So I am assuming there's no good way to check the rubber line on the inside? Oh well, if I'm going to replace the caliper, might as well replace the rubber line while I am at it, just to make dang sure I get it haha. Thanks.- Old Goat Ninja
- Post #3
- Forum: Axles + Brakes
-
RF sticks
OK, so my right front brake is sticking. It doesn't always happen. My rotors looked like the letter C, so I changed the rotors and pads this past weekend. Drove truck to work this morning, no issues. But on way home truck started pulling to right and sticking. I pull over. Right front is smoking...- Old Goat Ninja
- Thread
- Replies: 8
- Forum: Axles + Brakes
-
will 15inch aluminum rims fit?
All I can say is I have 15 Aluminum and they fit. Some people seem to have figment issues though. Mine fit fine. No idea what back spacing on mine is.- Old Goat Ninja
- Post #3
- Forum: Offroad Chat / Trail Ride Reports / Carnage
-
-
What axles do I have?
Stand behind truck and look at center of axle. Count how many bolts there are on the cover. 10 bolts = 10 bolt rear end, 14 bolts = 14 bolt rear end.- Old Goat Ninja
- Post #5
- Forum: Axles + Brakes
-
[Project] Complete Wheel Refurbish
Your gas door is open.- Old Goat Ninja
- Post #2
- Forum: Paint / Body / Detailing
-
First GM in quite a while...
Whew, lucky for you, you dodged that Dodge bullet!!! You owe that guy a beer! Welcome to the board.- Old Goat Ninja
- Post #10
- Forum: Introduction
-
A/C delete pulleys
AC delete works on 4 bangers, but that's about it. And when I say works, I mean it's a noticeable change. My DD is a 4 banger and I'll turn off the AC before the light turns green haha. Not that I'm racing, but you can feel the difference. As far as deleting, if it's dead, I'd delete it. The...- Old Goat Ninja
- Post #16
- Forum: Engine Performance + Maintenance
-
3:42's and 285's
Diesel? I honest'y don't know a lot about the older diesels. But I had an 07 Duramax that was lifted with 37's, and it was never regeared and that truck was still a rocket ship. Diesel has a lot of torque, at least the one I had did, and no problem over coming the much bigger tires.- Old Goat Ninja
- Post #3
- Forum: Axles + Brakes
-
******EMERGENCY!******
Take the lug nuts off, and then drive the vehicle really fast and make sharp right turns... it'll come off eventually :D HEY, kidding, do NOT do that!- Old Goat Ninja
- Post #10
- Forum: Axles + Brakes
-
black stock z71 rims
I've never seen stock Z71 rims painted black, so I can't say. But I've seen, and done myself, plenty of rims flat black and think they look fine. It's all about the prep work. And even then, they'll chip now and then. It's work to keep them nice. I have never seen a set of stock rims painted...- Old Goat Ninja
- Post #11
- Forum: Paint / Body / Detailing
