My '97 K1500 took Speed Bleeder brand 10mm x 1.5 (SB1015) on both the front discs and rear drums, despite their application guide calling for an 8mm x 1.25 bleed screw on the drums.
A few days ago the power door lock on the driver side of my '97 ECSB stopped working. Simultaneously, the window (manual) ceased to roll down more than a few inches. Hmmm, time to open up the door panels. I found that the rivets holding the power door lock motor to the inner door panel had...
I recently purchased Speed Bleeders for the front and rear of my '97 ECSB. 4WD with anti-lock brakes. Am I safe assuming that if I pull the stock bleed screws and replace them with the Speed Bleeders that any air introduced during this process will be downstream of the ABS unit and I won't need...
Not a bad question- but correct, blown with no trailer. Good suggestion, I will just wire my four-way flat plug into the existing wire tails left for that purpose.
Back in May I installed a cheap trailer wiring harness onto my '97 ECSB (Hopkins brand, Tees into factory light connectors). After blowing my taillight fuse two nights in a row I suspected that it may be the culprit and pulled it. No problems since then. Other wiring looks intact as far as I...