Shoot if that’s the case I may not need them.. I’ll be running a Holley term X max and a prodash
They were cut on the engine bay side and I have no idea what they go to.. i don’t even know what to look up in the diagrams .. I found a service manual but can’t find that piece.. found a picture...
does anyone know what wire does what on this pass through ? or where the wires go ? mines cut on the engine side and i need to know where to reconnect or even if i need to reconnect them
Hey Guys, doing a LS swap with a Turbo 6.0 / 4L80e and plan on running the Holley Terminator X Max and eventually put a pro dash in there.
I pulled all the old harness out and plan to thin it out. Should it be as easy as pulling out anything that went to the motor and transmission since...
ok thank you for the info .. yea i do plan to ditch the 10 bolt once i get the truck lined out.. in the process of a 5.3 turbo build and figured i'd do some brake upgrade by adding the hydroboost
WHat caliper setup are you guys running when doing this swap ? My truck is a 97 1500 and i got all the hryoboost stuff from same year 2500 diesel .. I got the hydroboost installed, deleted the ABS and put a proportioning valve from an earlier model... i still have drum brakes in the back for...
I do plan on a big brake upgrade just not right now -- is this something I would have to do now ?
Not Yet, I'm in the middle of doing a LS swap so was just doing the brake swap while i was at it
Just curious but why doesn't the vacuum booster pedal work ? I see there's about an 1" difference in the pins.. My truck is a 1997 so i got a reman hydroboost for a 1997 with a MC and everything lines up. the rod does have a slight angel going to the pin but still has a full range of motion with...
I'm guessing that's about were I will be. Mine is a standard cab short bed. With 5# of boost it Put down 324rwhp and close to 450 in tq through stock transmission and 3:42 gears..getting my trans built and a 2400 stall right now
I have a 97 C1500 with the 5.7 vortec and one of those side mounted Whipples. I have a 3" pulley on there right now and I believe people use the 2.75 to get a little more boost ? Where can you find one of these pulleys? And is it correct you'd have to run some type of water/meth injection if you...
i have a 97 C1500 pickup with the 5.7 vortec and a 4L60E.. i bought a B&M 2400 holeshot stall converter but when it came in it had on the box that said use for 93-96.. it will not fit 97 and later models.. I could of swore it said my year model online. Will it still work on my truck? What makes...