Long time lurker, first time poster here. I've searched for a few days and haven't found anything definitive on this
What size are the hex heads on our torsion bars? Specifically where they go into the LCA's. I've seen 1.75" thrown out but also 1.5" which seems too small. I've also seen conflicting reports on whether they are the same size on both ends or smaller on the key end.
1996 K1500 regular cab for reference, even though they should all be the same. Mine is wrecked and about to be rebuilt, so I don't currently have access to get an accurate measurement. I work at a machine shop and am going to build a set of torsion bar relocators.
Thanks
What size are the hex heads on our torsion bars? Specifically where they go into the LCA's. I've seen 1.75" thrown out but also 1.5" which seems too small. I've also seen conflicting reports on whether they are the same size on both ends or smaller on the key end.
1996 K1500 regular cab for reference, even though they should all be the same. Mine is wrecked and about to be rebuilt, so I don't currently have access to get an accurate measurement. I work at a machine shop and am going to build a set of torsion bar relocators.
Thanks