Getting around to addressing my brake situation. !st time getting into them.
Fronts look good. Greased sliders and pins.
Redid rears...new drums, shoes, hardware and wheel cylinders....would rather do many many many other things than rear brakes..wtf...
Still need to figure out my parking brake issues. Pedal to activate it doesn't seem to be working right...Clicks but I can pull it up by hand and my release handle wants to pull out of it's housing too easy....
Never used the ABS section of my scanner....
I put in 4WAL,light duty truck, non-linear egr.... and have a bunch of codes
36-Missing vehicle speed sensor signal
37-Erratic vehicle speed sensor
41-open isolation selenoid right front
42-open pulse width modulation selenoid right front
45-open isolation selenoid left front
46-open pulse width modulation selenoid left front
cleared them with scanner but they are not cleared when I read for them again...
There's a method in manual to jump a and h terminals on the aldl port but that's for when brake light is staying on....
No brake light on....
Brake light comes on koeo for a couple of seconds then goes away..
brakes work great....all this chasing around nice pedal feel was cured with actually having working rear brakes? ...... Haven't done any slamming of brakes yet...
Not being able to clear codes points to replacing bpmv in manual....
Fronts look good. Greased sliders and pins.
Redid rears...new drums, shoes, hardware and wheel cylinders....would rather do many many many other things than rear brakes..wtf...
Still need to figure out my parking brake issues. Pedal to activate it doesn't seem to be working right...Clicks but I can pull it up by hand and my release handle wants to pull out of it's housing too easy....
Never used the ABS section of my scanner....
I put in 4WAL,light duty truck, non-linear egr.... and have a bunch of codes
36-Missing vehicle speed sensor signal
37-Erratic vehicle speed sensor
41-open isolation selenoid right front
42-open pulse width modulation selenoid right front
45-open isolation selenoid left front
46-open pulse width modulation selenoid left front
cleared them with scanner but they are not cleared when I read for them again...
There's a method in manual to jump a and h terminals on the aldl port but that's for when brake light is staying on....
No brake light on....
Brake light comes on koeo for a couple of seconds then goes away..
brakes work great....all this chasing around nice pedal feel was cured with actually having working rear brakes? ...... Haven't done any slamming of brakes yet...
Not being able to clear codes points to replacing bpmv in manual....
Last edited: