-
-
DDantheman1540 replied to the thread Free to me GMC 2500.I’ll get back on the seats this week, but something I need for the rearend swap is a button for the E locker. Anyone have a good option...
-
-
DDantheman1540 replied to the thread Free to me GMC 2500.Tbh I got lost in the sauce over there. It was too much for a single morning poop reading session. I might have to revisit it. Anyone...
-
DI think so but I can’t confirm. Have you been through the bucket seat alternatives sticky thread? There’s a tooon of information about...
-
DDantheman1540 replied to the thread Free to me GMC 2500.I like the wrench! I’ll have to remove it and flip it over and look for a cable. Do you know if the motors can be replaced?
-
DI would think it would be cable actuated to release the slides when the seat is tilted forward. Of course comparing your picture to...
-
DDantheman1540 replied to the thread Free to me GMC 2500.If only we were all smart enough to read pictures. The handle clearly shows sliding forward as well as tilting. So something internally...
-
-
DSo, sitting in passenger seat, you reach under seat and moving that lever makes the seat back flip forward? :crazy:
-
DMy extended cab, manual 60/40, leans forward and slides with the rear egress handle. Both driver and passenger side.
-
DSo lower handle only controls forward/backward function and no seat back tilt? I just checked my bench and that’s how mine works.
-
DThe lower handle should lock the seat back into various positions and the upper handle should release the seat back, allowing it to...
-
DDantheman1540 replied to the thread Free to me GMC 2500.That passenger side seat has the same handle and it does control both. Also the lower handle does the same thing as the upper handle...
-
DI don’t think that controls both seat functions. My bench has forward and back controlled by lever under seat. My former 400 single seat...
-
DDantheman1540 replied to the thread Free to me GMC 2500.Lots of measuring and lots of using my digital angle finder and I think I got it setup right. I’ll find out when I go to bolt it in ...
-
-
DDantheman1540 replied to the thread Free to me GMC 2500.Got the axle cleaned up today. Might do a bunch of measuring and get everything tacked into place even. I don’t have 220 in my shop so...
-
-
DI think this should have been a option dose not matter if you have a short bed/step side or a long bed you should have been able to pick...
-
-
Loading…
-
Loading…
Members online
- Harley5425
- gilly327
- ObsCam
- docstoy
- roaming_art
- Jlojub
- johnckhall
- RichLo
- 99xcss4
- scott2093
- 0xDEADBEEF
- 454cid
- TonyM
- rdobirdman
- Kylebg94
- Supercharged111
- caw_86
- Colek1500
- AlexG87
- Drunkcanuk
- _2drhoe
- GMCBurb99
- OutlawDrifter
- Charlesteneows
- Kmarkst1
- fancyTBI
- tayto
- man-a-fre
- HighSchoolTruck
- gijoe3922003
- mhau93obs
- markusmawa
- Travon
- TX97z71
- kcmo-obsaddict
- 93Xtra-Cab
- KleenScottsdale
- BNielsen
- matt87
- Blazvick
- druville
- Os-mark683
- Keeper
- obsguy3744
- lhoop32
- Das Hatt
- GravyJones
- the_elegant_fox
- GrimsterGMC
- Kejob