WILWAXU
I'm Awesome
Yup, LineX spray in.A lot of inspiration here for my stepside.
I really like that bed setup. It looks like you did a spray in liner at some point?
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Yup, LineX spray in.A lot of inspiration here for my stepside.
I really like that bed setup. It looks like you did a spray in liner at some point?
I bet you had a ton of fun getting that out of the cross shaft.If you know what this is, you know how much fun it was to get out
You must be registered for see images attach
You know it! I bought the removal kit, so it wasn't too bad. A lot of trouble for a leaky seal.I bet you had a ton of fun getting that out of the cross shaft.
Why?, because you can't get the axles out without removing the pin. This is a very common problem with these bolts.How’d you do that... or better yet, why?
Sent from my iPhone using Tapatalk
Why?, because you can't get the axles out without removing the pin. This is a very common problem with these bolts.
Leaking seal on the passenger side. So, I'm replacing the bearings and seals on both sides.Now that I’m actually able to find where that bolt goes... it makes a heck of a lot more sense. I googled cross bolt and everything that initially came up was pointing toward a front end suspension component. Lol. I haven’t gotten that far into my rear diff project to know any better.
Why are you pulling axels? Replacing bearings?
Sent from my iPhone using Tapatalk