You must be registered for see images attach
Hopefully someone in here has had this issue before, three shops and no solution. Having a brake issue I'm going to attempt to solve this weekend, here is a list of new parts to help you all narrow it down.
New Transmission and Torque Converter by Overhaulin Transmission of Savannah Georgia.
New rebuilt drum brakes, front rotors and pads, calipers aren't locked up, new wheel bearings.
New brake reservoir.
All new A/C lines, condenser, filter, Evap and Heater Core, compressor, blows hot and cold.
New front end steering, pitman arm, idler arm, center link, inner and outer tie rods. AC Delco and Moog only, all greasable and greased up.
New upper and lower control arms both sides.
New Upper and lower ball joints Mevotech TTX's both sides, greasable and greased up.
BellTech 3 inch lowering springs and Street shocks up front.
New BellTech 4 inch drop shackles and hangers, and belltech lowering shocks around back.
BellTech transmission carrier bearing spacers to fix driveshaft angle.
New AC Delco carrier bearing.
New spicer ujoints from the yoke to the transmission tail shaft.
Custom shortened and balanced driveshaft by Powertrain of Savannah Georgia.
New 235/75/R15's GT Radial HWY Terrain's, road force Balanced.
Fresh alignment after tire install, tracks straight down the road.
Only issue is the rag joint is shot on the steering shaft. Ordering a universal joint shaft from Cunningham machine asap.
With all this ABS light cycles on and off, randomly. Front right rotor seems to have warped overnight after the new tires got installed. after solving all the issues with the driveshaft and the new tires. I bled the brakes but apparently the ABS modulator/Accumulator needs a scan tool to initiate the bleed. I've seen online there is a manual bleed with two valves on the Accumulator. Oddly enough as well the "warped" rotor is passenger front but it's not completely consistent. Diagnosing intermittent issues sucks taint.
Also, there is a weird what feels like a bad wheel bearing but it's very faint coming from the gas pedal. The damn wheel bearings are brand new and have no play. I'm going to inspect when I replace this rotor and bleed the brakes.