Need help with power locks on base doors

[Treyes]

I have a 92 c1500 with manual everything but i want to install power locks with a viper alarm is it possible or what should i do instead? Do i have to drill a hole in my doors for the wires? Do i need anything else to provide the system with power? Can someone that has something similar help me out?

 

[1997]

installed a 2 door 5 wire kit similar to this:
https://www.ebay.ca/itm/12V-Univers...ash=item2cf548b720:g:S54AAOSwispddvyI&vxp=mtr
used my clifford alarm to arm and lock, easy installation. doors have rubber for wires to connect to cab in place. only drilling was to mount door lock actuator. mounted relay box behind driver side kick panel.

 

[Treyes]

installed a 2 door 5 wire kit similar to this:
https://www.ebay.ca/itm/12V-Univers...ash=item2cf548b720:g:S54AAOSwispddvyI&vxp=mtr
used my clifford alarm to arm and lock, easy installation. doors have rubber for wires to connect to cab in place. only drilling was to mount door lock actuator. mounted relay box behind driver side kick panel.

Thanks for the help. One more question were did you wire the relay too? I have a 92 so idk if it’s different from your 97

 

[1997]

i put in a fuse and attached to the same +12v always on power that Alarm used.