Jeep 18" wheels on my stepside

[Gticket]

I had em for a long time, when it was stock height and after the spindle lift. Never had a problem and I ran 2" all the way around

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

Nice. Where did you get the center cap? And what spacer did you buy?

 

[dusterbd13]

So, bumping..

Im seriously debating this swap.
Truck is a c1500, dropped 2/4

The front spindles push the wheel out 1/2 inch per side.

To get everything to clean the fender ls, id go 1.5 front and 2 rear spacers, right?

 

[Dubs]

I'm not sure. To keep everything even if sounds right. Measure your rear end to make sure. You might be able to do 1.5 all the way around

 

[jaimesauce]

So, bumping..

Im seriously debating this swap.
Truck is a c1500, dropped 2/4

The front spindles push the wheel out 1/2 inch per side.

To get everything to clean the fender ls, id go 1.5 front and 2 rear spacers, right?

Did you decide on going with 1.5" or 2" spacers? In the proccess of dropping the truck in the near future.You got any photos of how the truck is looking .