composite to dual sealed beam

[eran tomer]

hello
i bought from LMC the dual headlamp assemblies with the stock bulbs.
need to figure out how to connect them.
i found in the parts diagram there are 2 jumper harnesses for the lamps #12046532, they are available here and there. is that what is needed? where do you connect the 4 pin plug?

or is there another solution?

You must be registered for see images attach

You must be registered for see images attach

 

[mars2878]

I've never seen that harness jumper before, didn't know that it existed.


When I did mine, I cut the 9005/9006 plugs off & grafted on the mini-quad plugs on. Soldered the wires & heat shrink tubed them. Added electrical tape just because & reinstalled the wire loom. This harness is now in it's 2nd truck & I made it about 10yrs ago. Never a problem.

 

[10mm Nut]

Same here. When I backdate to the dual sealed beams I just splice the wires with solder and heatshrink. The colors are the same, just match them up.