Ball joint spacers and front diff. Drop.

[TLoud]

You must be registered for see images attach

IFS by TLoud, on Flickr

 

[barebones 1500]

^^^What's up with the pic man?

 

[TLoud]

oh wtf that was a pick of the front end how the hell? lol ill try again.

 

[Swaggerwagon]

It's been done before...a few times...

 

[shrekmoose]

Does anyone know of anything floating around in the interweb world where this has been done?

 

[MOBS]

Is it just me, or would spacing the lower ball joint in essence do the same as lift spindles?

 

[Swims350]

I forget how they are, i think the 4x4 lower bj points downward which wouldn't lift anything it would lower it? I aint looked at mine in awhile.

 

[MOBS]

Oh I was looking at Tloud's diagram, it looked like it pointed upwards, which would relocate the bottom of spindle further down lifting the front. My memory has sucked lately, especially with the 4x4's. Sold my Ducks Unlimited model and haven't touched a 4x4 since lol.

 

[Swims350]

maybe it is right I forget how mine is so don't quote me on it. but on the lower if it does point as shown.. spindle on top of the LCA and you used a spacer or did a flip wouldn't that lower it? I'm confused lol.

 

[Southern Pride]

I had a z71 canyon which also has torsion bars and mine were cranked almost 4 inches. Now with that being said my cv angles and all were almost at stock angles

Reeaallllyyyy... 4" and stock angles... Surely I don't need to explain my skepticism.