5speed swap

[Conman1181]

Appreciate it bud, I'll go back over real good.

 

[Conman1181]

Only thing I can say is check the harness. It's easy to pinch a wire under the bell housing. Also check your grounds.

Sent from my SM-N960U using Tapatalk

I rechecked the harness, and turns out, the extension harness used on 4x4s was unplugged. Plugged it up and the speedo is working fine, just about 10mph off.

 

[Mike Alexander]

Trigger_guard did you have to use a seperator plate between the block and flywheel? I'm looking at converting my 4l60 to a nv4500

 

[Trigger_guard]

Trigger_guard did you have to use a seperator plate between the block and flywheel? I'm looking at converting my 4l60 to a nv4500

Nope, I think that's more of a Ford thing.

Sent from my SM-N960U using Tapatalk

 

[Mike Alexander]

Ok awesome, thanks!!!

 

[GTZ71]

Well it’s been a while but plans have changed. Picked up a 6.0 for it. I’ve always wanted to do this but I’ve always herd that it would be smarter and cheaper to just build the 350 vortec that was in it. But this 6.0 apparently runs and I got it for $300. I’m taking it to the machine shop Tuesday. I’ve never tore into a motor this deep before but I hope if I have questions I can find the answers in this forum.

You must be registered for see images attach

Sent from my iPhone using Tapatalk

 

[Supercharged111]

If it runs, just stick it in the truck as is.

 

[GTZ71]

If it runs, just stick it in the truck as is.

I’ve already got it torn down and ready to go to the machine shop. I don’t want to have to take it back out again [emoji23]


Sent from my iPhone using Tapatalk

 

[Supercharged111]

You let the magic smoke out. . .