4L60E Output Shaft Stuck

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

John P

Newbie
Joined
Oct 15, 2017
Messages
25
Reaction score
4
Location
Levittown, Pa.
I have my 4L60E just about apart but I cannot pull the output shaft out of the Trans, it’s as if the Reaction Gear is pressed into the output shaft, i tried everything it will not move. Do I need to press it off?

You must be registered for see images attach
 

John P

Newbie
Joined
Oct 15, 2017
Messages
25
Reaction score
4
Location
Levittown, Pa.
We’ll, I solved my own problem, I put it on my Harbor Freight 12Ton Press and with slow steady pressure, it pushed right out the bottom. The gear has a small pin on each side of the shaft that made it stay on so tight Hope this helps someone else.

You must be registered for see images attach
 

Kolton5543

Newbie
Joined
Oct 15, 2017
Messages
2
Reaction score
1
Location
Safford, AZ
Putting a transmission under a press seems a bit sketchy to me. Kinda odd that it was in there that tight. I've removed probably 10 different shafts and they all would fall right out of the bottom upon releasing the snap ring
 
Top