1993 6.0 Swap

[HPIII]

I am installing an L96 6.0 with a 4L80E into my 2wd 93. Any suggestions for Camshafts and torque converters? I believe I'm going to delete the VVT.

 

[HPIII]

Well, went with a Brian Tooley Racing stage 4 truck cam, ls7 lifters and ls6 valve springs. Looking at torque converters now.

 

[RDF1]

What's the cam specs?

Sent from my SAMSUNG-SM-G870A using Tapatalk

 

[HPIII]

Cam Specs are 224/230 .553/.547 111+2

 

[RDF1]

What gears you planning on running?
I'd say a 3200 or tight 3600 stall if you really wanted it to move.

Sent from my SAMSUNG-SM-G870A using Tapatalk

 

[HPIII]

What gears you planning on running?
I'd say a 3200 or tight 3600 stall if you really wanted it to move.

Sent from my SAMSUNG-SM-G870A using Tapatalk

3:73’s most likely. The truck currently has 3:42’s but as soon as I get the Engine/Trans swap complete I’m going through the rear end.

 

[HPIII]

Ended up going with a Yank SS3600.

Removed the old engine and transmission. Ordered a psi conversion harness, recieved the 4l80 back from the transmission shop, engine mounts on the way. Hopefully I will get it set in the truck soon.

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

 

[HPIII]

Engine and transmission are in the truck. Installed the headers as well. Had to move the transmission crossmember and figured out that I will need a different driveshaft yoke.

You must be registered for see images attach

You must be registered for see images attach

 

[Kbach]

What did you get the 6.0 out of? Looks like a truck engine (taller)? I've got a 91 2wd I'm looking into doing either a 6.0, or 6.2 with a 6 speed auto, not sure yet if tranny will fit in the truck. Looks like you did a great job on the install!

 

[blacksport]

good info in video

xc_hide_links_from_guests_guests_error_hide_media