4x4

  1. psteinke63

    NC Unicorn!

    I have finally completed all the littel repairs and I have listed the truck on Bring-a-Trailer. Here are my pics. if it doesn't get the reserve I will probably just keep it...
  2. Kris_96_57_350

    1996 K2500 8-Lug 6” Lift / 2-Piece Driveshaft Question

    1996 K2500 8-Lug 6” Lift / 2-Piece Driveshaft Question. I have a 1996 Chevy K2500 4x4, 8-lug, automatic, extended cab long bed with the 2-piece rear driveshaft and carrier bearing. I’m trying to figure out the best 6” lift option. I was originally looking at the Tuff Country 16822KN 6” kit...
  3. lorenzohuichapa

    Hello from West TX

    Hey everyone, I’m a 17yo from West Texas. I’m working with a 1996 GMT400 that my dad gave me and I’m trying to do things right with it. Any tips or advice are welcome. Excited to learn and see what everyone’s running. It’s a 96’ K1500 extended cab step side, currently has a blown 350 but looking...
  4. psteinke63

    What is value of my '95 K1500 with Standard Drive?

    I have a 1995 Blue Silverado with a manual tranny and 4x4. I can't find them listed anywhere online and need to know an approximate value. No Rust, 175k on body 5k on Jasper engine. AC serviced last summer, new clutch being installed now. Just got married and have to reduce my vehicles. Blue...
  5. C

    Tranny swap

    Im looking to swap my 89 700r4 for a 92 nv3500 if itll bolt up to my motor and if i could swap the transfer case because it looks like the 92 has a vacuum actuated t case, has anyone tried this?
    • crippybred
    • Thread
    • 4x4 tranny swap transfer case transfer case control module transmission
    • Replies: 4
    • Forum: Transfer Cases
  6. Bushoku

    1990 Chevy K1500 Silverado Stepside

    Starting a build thread after securing this truck from Bring A Trailer: https://bringatrailer.com/listing/1990-chevrolet-c1500-pickup/ Flew from MI to PA to drive it home a month ago and the idler pulley seized up along the way, ripping the water pump apart and emptying all the coolant across a...
  7. Backpack96

    No 4hi

    I have a 1989 GMC K1500 with a 4.3 700r4 and an Np241c. My 4lo engages flawlessly every time but when I try to engage 4hi it doesn't matter what I do it does not engage. The front drive shaft feels locked in (will not move by hand) but it does not engage the wheels. If I try to spin the...
  8. C

    Transfer case switch - 2 pin to 3 pin conversion on 94 K3500

    Fixing Chevy 3500 dually diesel for a buddy. 4x4 not engaging, no lights on the floor shifter. He said he replaced the actuator in the axle. I figured out taht the transfer case switch must be bad. Pulled the connector to verify the type (auto parts stores offer 2 kinds - 2pin and 3pin) and...
  9. Angelo

    Right tire for drw 96 Cheyenne k3500

    I have 215 85 16 tires on it. That's what was on it when I bought this ambulance, the old tires were from 2005 and I replaced a couple years ago. Need to replace at least the rear 4 now, they're showing uneven wear. When doing research on a tire I found on marketplace I input my vehicle details...
    • Angelo
    • Thread
    • #biggesttires #k3500 4x4 drw tire size
    • Replies: 15
    • Forum: Axles + Brakes
  10. Da_Droid_Mechanic

    99 GMC Burban' K2500 Shifing into 2nd gear slow

    It seems to be shifting slow and almost hard, quite jarring... Def not smooth haha Its got the 4l80e (rebuilt 4 years ago) and a new 454 (installed 2 years ago) btw Any suggestions would be super appreciated!!
  11. SR104

    4WD fuse blown

    Hey fellow GMT owners, I’ve got a question… My floor shift T-case light recently stopped coming on when shifting into 4H and also would always grind when trying to put it into N or 4L, but it’s done that the entire time I’ve owned the truck so I’m not really concerned about that (though if I...
    • SR104
    • Thread
    • 4wd 4wd light 4x4 blown fuse transfer case transfercase
    • Replies: 23
    • Forum: Electronics
  12. J

    94 cheynne Radiator

    bought a replacement radiator for my 94 chevy Cheyenne 4x4 4.3v6 and its smaller than the orignal. Can i still run it?
  13. Fobra

    front differential not engaging

    So I bought my 96 GMC Yukon 5.7 4dr with the electronic 4x4 (switch on dash) a couple months back. The previous owner made it clear that the 4x4 doesn't work, after all it was a project truck at the time he sold it to me. I'm just now getting around into working on the 4x4 and the previous owner...
    • Fobra
    • Thread
    • 4x4 4x4 issues 4x4 not engaging diagnose diagnostic fromt differential front axle help offroad transfer case
    • Replies: 8
    • Forum: Transfer Cases
  14. Midi_muk

    Torque converter recommendations for lt4?

    Hi! I’m curious if someone else has ran the lt4 hotcam in an l31 with a 4l80e and as changed the torque converter from the stock one. I’ve read the stock converter does like 1500-1800 stall and that the lt4s are better with a higher stall. I’m not sure what a good one would be. It’s a 1997 k2500...
  15. denali

    My 2000 GMC Yukon Denali

    Introducing my '00 GMC Yukon Denali. Owned by our family her whole life and maintained by my parents with pride. Lots of childhood memories in those third row seats. Bought from my dad and shipped across the country to use as my daily driver. She sat in the garage for a long while, so I've...
    • denali
    • Thread
    • 2000 4l60e 4x4 5.7 vortec denali gmc yukon
    • Replies: 18
    • Forum: Member Trucks
  16. D

    PG Powergo headers

    Howdy all. Did an exhaust leak test on my 90 K1500 4x4 5.7 and found multiple leaks everywhere. Talked to a few shops and from the ballpark estimates, I’ve decided to do it myself. Ordered a set of those PG Powergo short headers from AMZ. Supposedly they will bolt up to the OE collector...
    • Direwolf
    • Thread
    • 1990 4x4 5.7 tbi exhaust system k1500
    • Replies: 11
    • Forum: Exhaust
  17. Whitsican

    Lowering 4WD Basics

    I’ve got a ‘92 Chevy K1500 I’ve done some research collecting answers. She’s pretty level 6” wheel gap in the rear 6.5” wheel gap in the front. I’m wanting to lower her without having to notch the frame nor take extra unnecessary steps. From what I read I can probably lower it 4” front and back...
  18. dasburb

    1997 K1500 5.7 suburban exhaust compatibility

    Hi everyone, I have a 1997 Suburban which has a vortec 5.7 and a style of exhaust which has two pipes that are separate leading into the muffler. It looks like the picture below What I'm wondering is if a slightly newer exhaust system from a 99' would be intercompatible AND allow for me to...
    • dasburb
    • Thread
    • 1997 4x4 5.7 5.7 vortec california compatibility emissions exhaust k1500 oxygen sensor
    • Replies: 20
    • Forum: Exhaust
  19. AC89K2500

    Stock 350 3/4 ton transmission options

    Hey Everyone, my name is Ashton from Iowa. I recently acquired a fairly clean ‘89 3/4 ton Chevy with a stock 350 small block. It currently has the 3 speed manual which I find to be horrendous for anything above 55mph. I’m looking into the idea of a 4l80 swap and was wondering if anyone has a...
    • AC89K2500
    • Thread
    • 3/4ton 350 4l80e swap 4x4 long bed standard cab
    • Replies: 40
    • Forum: Transmissions
  20. thxrxsxkh

    Lower control arms

    Hey, y’all! I’m trying to rebuild the front end on my ‘94 K1500 pickup and I’m having the hardest time finding lower control arms for this thing. I knew it would be hard but I didn’t know it’d be close to impossible. I’ve looked aftermarket and OEM. What are thoughts on pulling and maybe...
  21. G

    Wheel sizes for lowered k1500

    Im new to all this and just wanted to know what wheel sizes i can run on my 95 k1500. It has a 4/6 drop and theres slight rubbing on the front but im going to get my fenders rolled soon.
  22. N

    1992 Chevrolet K1500 5 speed Manual, front drive shaft replacement help (Very new topic for me) What should I know?

    Hello all. I am purchasing a 92 K1500 5 speed Manual with a 350 small block, off of someone who is moving away. The pevious owner removed the front drive shaft and the guy I'm getting it from said he believes the U-joint probably went bad. He mentioned the shifter does seem to get stiff/stuck...
  23. TheRedMamba

    Cooling System Upgrade/Replacement

    Yo! A little expertise please! I've recently been dealing with a busted upper radiator hose connection, so I'm needing to replace the entire radiator. Here's my plan.... I went to the boneyard Saturday and scored a super clean 41" radiator out of a 1 ton Sierra, obviously Babygirl came from the...
  24. T

    Not starting after doing a De-Carb on engine

    I really need help! Yesterday I did an engine de-carb on my 1988 k2500 at work. Nothin unusual happened while i did the de-carb and I even drove it home after without any issues. However after letting it sit all night i went to start it this afternoon and it doesn't crank I only here the starter...
  25. T

    ECM trouble dtc 51 PROM error

    I recently purchased a 1988 Cheyenne K2500 4X4 and a couple of days ago the truck stalled while idling at a red light and the power seems low when accelerating. I got home and noticed the SES light came on so I checked for any codes and I got code 51 which says there an error with PROM. I...

Latest posts

Members online

Total: 2,188 (members: 45, guests: 2,143)

Forum statistics

Threads
77,811
Messages
1,640,264
Members
80,492
Latest member
subven69
Top