Search results

  1. justin93

    SAS 93' K15 - D60 79' F250 Snow Fighter: Steering/Springs/Brakes

    I'm in the process of assembling my Dana 60 from a 79 F250 Snow fighter and 14 Bolt FF 73-87 Blazer (10.5") I will be swapping this in my 1993' Chevy K1500 which I hope to throw some 40-42's on when the SAS is all done. I am putting the running gear together right now and I thought I would...
  2. justin93

    Clearing 22x14 Rims lock-lock ~ 1 Ton SAS

    Hey everyone, Im in the process of my SAS on my 93' K15 and came up on a killer deal on 22x14's wrapped in 37x13.5 tires (475$ For rims+tires) and was wondering what it might take to get these to fit with no rub if even possible. I am aware of the ride rate issues that derivate from adding...
  3. justin93

    Upper Shock Hoops vs Stock Shock location - Pro Comp 6" Lift

    When I initially purchased my K15 on 35" bald tires exposing the wire cords, it had the 1st gen Pro Comp suspension lift kit on it. There were a few concerns initially but with any used vehicle there was already plenty that needed TLC. Now after going through just about more then I would...
  4. justin93

    Rear axle swap/upgrade - Suggestions?

    I have a '93 K15 350 sbc, 4l60E trans, 1/2 ton 6.5 ft short box, with drums in the rear. I recently have been pricing gear swaps for my truck and have had the same number come up from 3 different shops 1800$ front and rear 4.88's with master hardware NO DIFF INCLUDED... :Whoa: I paid 1700$...
  5. justin93

    Brake upgrades? Add Pics

    Just as the title says, Post up your pictures of your brake system. If modified or not; im considering putting a new rear brake system and returning my Master Brake (o reilly's rear drums) and getting something with a little better braking capabilities. I will be changing out my gears and all...
  6. justin93

    Wheel Clearance 6" lift suspension 3" body lift - Clear 37 x 13.5 R20 12" Width

    As the title says. I have a 1993 chevy K1500 1/2 ton 5.7 TBI 4l60E currently on 35" 12.5 R15 10" width 6" Pro Comp lift suspension with 3" body lift. I've been contemplating going the size in the title but am i able to clear the 13.50 tire width without rubbing? i will take some fender...
  7. justin93

    Brake pedal gulping - HELP

    Hey everyone, Pretty general thread here but i figured i'd get better opinions here then just my own. So i've replaced my front brake rotors, with seals and bearings, rear Drum hardware, wheel cylinders and Drums. I had mismatched axle shafts as well and one looked like it had seen better...
  8. justin93

    Blacking out - Refinishing black on all exterior trim HELP

    Hey everyone, i recently painted my OBS, and have been in the process of refinishing every part on it as they were mostly chrome. I would like to refinish my door handles, my ext cab window trim, and my driver/passenger side door window trims. They're looking scuffed up and uneven...
  9. justin93

    Aftermarket Projector headlights.. LED RIM flickering/NO low beam HELP

    I already tried calling the manufacturer and they have a loop holed self contradicting return/exchange policy so returning these/buying a new pair swapping out the bad for a good one and returning wont work.. I was wondering if there's anything i can do to test this? I have access to shop tools...
  10. justin93

    Door Hinge Sagging - Won't close all the way

    So my door doesn't like to close flush, it sits out a good 1/2" from the lines it should be pressed against when the door is shut. I've already replaced the pin lock nuts and bushings on both top and bottom.. and i tried using the sliding hammer to adjust the door strike receiver but have had...
  11. justin93

    Fox shocks 6" pro comp lift HELP

    I just installed my passenger side side shocks with a set of the 2.0 remote reservoir shocks on my 6" pro comp lifted K1500 with the double hoop and third lower shock mount. I was wondering if anyone else has these shocks on there setup and what they used to replace there lower 3rd shock ? I...
  12. justin93

    Lower Valance HELP! Wrong Fasteners - What are YOU using ?

    So i used to have this nasty looking gap between my front ARB bumper (initially a Tundra 'sahara' model bumper) and i just repainted the truck and including the valance that was never able to sit snugly under my grille. I was wondering if these fasteners are what you guys are using, as they...
  13. justin93

    Fog lights install? ARB Bumper 93 Chevy K1500 HELP!

    I'm having trouble Finding a way to hook up my fog Lights on my ARB bumper. I have no wiring harness that came with the bumper just whats shown in the picture. Here's the manual for the bumper installation here http://store.arbusa.com/Assets/PDF/3462030i.pdf
  14. justin93

    Steering lockup HELP! Borgeson Steering Shaft rag joint

    Hey everybody i've been having the worst luck, my steering locked up entirely and the power steering pump failed about 3 months ago, i then replaced the power steering pump and presto - working just as normal again. NOW - 3 months forward now i JUST had my truck painted at an AUTO BODY PAINT...
  15. justin93

    Rebuilt 4L60E HELP!

    I purchased a 93' K1500 with a rebuilt engine and trans with 31k miles on both the 5.7 SBC TBI and 4L60E I was wondering the rebuilt condition of my transmission - the only notations i can make of its current performance is the following.. - When shifting into gear from park to D it will...
  16. justin93

    Re-Gearing 93 350 SBC TBI 35" Tires 4.56's ? - Suggestions ?

    I have a 1993 Chevy K1500 with a 350 TBI (non-vortec) and 4 Speed auto w/ OD Transmission, i believe the 4l60E. It has 9" of total additional lift. 3" body lift 6" lift suspension 35"x 12.5" x 15R It has stock gears which is 3.73 - To my knowledge from spinning the DS and marking the...

Latest posts

Staff online

Members online

Total: 1,120 (members: 43, guests: 1,077)

Forum statistics

Threads
64,185
Messages
1,388,513
Members
51,111
Latest member
elvlack89

Share this page

Top