Search results

  1. _rgk

    Coolant temp sensor - what is a good replacement?

    Not sure why you guys are shopping for car parts on Amazon. Rockauto has the best prices and selection. They just about never get parts wrong if you know your year make and model. GM Genuine 213928 AC Delco 1551107 I like Standard sensors. Can’t beat that three-year warranty and all their...
  2. _rgk

    No Reverse lights

    On my 98 auto 4x4 the switch under the dash with the green wire is NOT for the backup lights. Instead, the neutral safety switch/backup light switch is on the drivers side of the transmission, near the driveshaft. In any case for me the problem was in the tee connection to the trailer wiring. It...
  3. _rgk

    P0440 Code Tip

    Lord almighty. Same here. Thank you!
  4. _rgk

    TPS percentage wobbling

    I hooked up a scan tool today and noticed that, at idle, the TPS percentage wobbles between 0% and 0.4%. I replaced the TPS, with no change. Has anyone else experienced this? I heard someone else say the connector might need to be replaced. What do you all think?
  5. _rgk

    Is this an oil pressure stepper motor issue?

    Oil pressure sensor is new
  6. _rgk

    Is this an oil pressure stepper motor issue?

    Ok, looks like it will take care of a flicker: https://www.gmt400.com/threads/instrument-cluster-question.44675/page-3 I’m wondering whether what I have is a flicker or whether it’s supposed to move up and down that quick. Like maybe it’s supposed to move more like a coolant gauge?
  7. _rgk

    Is this an oil pressure stepper motor issue?

    I’m wondering whether replacing the stepper motor behind the oil pressure gauge will smooth it out.
  8. _rgk

    Fuel pump relay connections

    I know I have voltage on the signal side and I know the pump runs fine when jumping it and I know I have good fuel pressure. I tested the relay and couldn’t get it to not work So … I’m thinking it’s a bad connection.
  9. _rgk

    Fuel pump relay connections

    Pump is fine. Engine is acting on backup signal from oil pressure sender. It’s going to be either the connection or the relay. My money is on the connection. If anyone can help me determine the right replacement pin to get that would be helpful.
  10. _rgk

    Fuel pump relay connections

    I think it is. I had trouble starting it until I wiggled the relay. I’ve tested the relay and it tested fine. I think it might be this pin but it’s hard to tell: https://www.clipsandfasteners.com/SearchResults.asp?Search=A14883&Search.x=10&Search.y=9
  11. _rgk

    Fuel pump relay connections

    Welp it’s still got a hard start once in a while and when it does I don’t hear the fuel pump kick on. Where do ya’ll get your new pins?
  12. _rgk

    Fuel pump relay connections

    Small block and upgraded the spider.
  13. _rgk

    Fuel pump relay connections

    Today I looked at the fuse box closer and saw that it’s held in place by three bolts accessible from the wheel well. I removed these and was able to remove the fuse box support. Then, after some squinting and head-scratching, I figured out how to press the plastic tabs and detach the bottom of...
  14. _rgk

    Budget headers

    Where do you shop for these?
  15. _rgk

    Budget headers

    Stock exhaust, would like to upgrade to headers on a budget. What should I look for on Craigslist and Marketplace? I am not seeing any headers coming out of a pickup, so how do I know which ones will fit? Also, what’s the difference between short tube and long tube headers, performance-wise?
  16. _rgk

    5.0 engine knock on start up only

    My Nissan did this. It turned out to be inadequate oiling at the timing chain. It would only do it when cold, not when at all warm or driven that day. The inadequate oiling was due to worn bearings, which also caused a rod knock. But this knock surfaced only at 3-4k rpm.
  17. _rgk

    Weird Factory Interior Question

    Which one do you miss the most?
  18. _rgk

    Fuel pump relay connections

    Do you need to flip the fuse box upside-down to get at the connectors? I imagine I won’t have enough wire to pull them from the box right-side up.
  19. _rgk

    Fuel pump relay connections

    Typically I like doing the correct fix, but getting the terminals off through the fuse box plastic housing seems to me like a nightmare.
  20. _rgk

    Fuel pump relay connections

    Fuel pump relay is sitting in the terminals loose. This is causing an intermittent connection gap. When it’s hot I have trouble starting the truck. How can I fix this? Is it possible to pull up the fuse panel and bend the terminals back? Is there an easier way?
  21. _rgk

    1998 Gmt400 4x4 Z71 Ext Cab

    What kind of wheels are we looking at here?
  22. _rgk

    Engine Oil Cooler Question

    I'll eat your wife's lobster muffin, if you don't want to.
  23. _rgk

    Sender sends high temp

    I didn't want to open the back cover on the new pump, and you wouldn't be able to see much in a photo without that open. But I did see through the outlet that both sides were cast correctly. I installed the pump and heated up the truck. With the thermostat sensor reading 190, the gauge sits...
  24. _rgk

    Sender sends high temp

    Holy moly, look at these pictures. Normal water pump outlet to passenger side head. Driver's side outlet mostly restricted by what appears to be a casting flaw!
Top