Search results

  1. Ed Hardy

    Fried Fuse Box

    Would that fit a 91 suburban? Because I am if he ain't.
  2. Ed Hardy

    91 suburban still Dead in the water no pulse at injectors

    I have found no alarm system no cobra no bulldog nothing like that this this truck didn’t even have key fobs. But I have come across shopping kind of interesting. The ECM up all over eBay has a chip the problem chip for the transmission is a Z one industries Prachya looked it up I’ve attempted...
  3. Ed Hardy

    Gear selector silly question

    There is no pulse I cannot get this damn thing to pulse. I tried faking it out by grounding it out. She will start if I run a wire from the battery negative to the Data side of the injectors the blue and green and she will start when I connect those two gator clips. But like I said only for a...
  4. Ed Hardy

    Gear selector silly question

    I have no pulse at injectors/ for injectors. I made her fire up the other night by grounding out the blue wire on the injector connectors. She fired up on her own, I did not have to assist her and spoonfeed her fuel. she only ran for a minute and then popped the breaker/fuse. Ive bought yet...
  5. Ed Hardy

    91 suburban still Dead in the water no pulse at injectors

    I have 12 volts at the injectors I also have 12 V at the ECM. The only wires are grounded out or shorted is the gray wire. It doesn't go to the distributor it goes to the well your safety switch to the tank fuel pump and they fuel switch relay. That's the only one I could fine except for the...
  6. Ed Hardy

    91 suburban still Dead in the water no pulse at injectors

    Well I won’t guarantee it’s not the fuel pump after all I did buy through Amazon but there again I can’t disprove anything else either. The gentleman before you with the ignition issues has a valid point also but I can't just disprove him either. I of put two of everything on this truck and the...
  7. Ed Hardy

    Gear selector silly question

    I can say is not the neutral safety switch what can I say that is rewarding? She fired for the first time in over a year without pouring fuel Down her throat! If I could just keep it up that would be even better news wouldn't it? The problem is that she blows the fuse every time she does it...
  8. Ed Hardy

    91 suburban still Dead in the water no pulse at injectors

    IMO? Sorry I'm not familiar n. What RPMs I was sitting in the shop and in park at idle speed.
  9. Ed Hardy

    91 suburban still Dead in the water no pulse at injectors

    No there's no alarm. Ive been over every square inch of this young lady. I have touched and traced every wire and I've looked at every box. get your mind out of the gutter. she was running strong. Hi installed 12 gauge it including GPS Speedo and tachometer and a new consul. I buttoned...
  10. Ed Hardy

    91 suburban still Dead in the water no pulse at injectors

    Send money or just mail me yours. Ill send it back when I get her to blast off. Just saying. I've already admitted that I'm flat broke
  11. Ed Hardy

    91 suburban still Dead in the water no pulse at injectors

    Now see you're the first one to say something in regards to the high pressure end of this throttlebody. when I rebuilt my old one (multiple times) my fuel pressure regulator spring was 58 to 62 pound Spring. It was also different than any color of any rebuild kit. Canadian built, it was...
  12. Ed Hardy

    91 suburban still Dead in the water no pulse at injectors

    I have a gauge mounted in line at/on throttlebody for fuel and Oil at the oil pressure fuel pump safety switch.
  13. Ed Hardy

    91 suburban still Dead in the water no pulse at injectors

    I have fuel Ive washed the cylinders several times just checking and rechecking to make sure I have an ample supply petrol coming to the back of the throttlebody. A bee in the fuel filter WTH now that is a strange one. There's a joke somewhere in that but apparently my humor isnt funny within...
  14. Ed Hardy

    91 suburban still Dead in the water no pulse at injectors

    If fuel pump goes whirrr like it’s supposed to when I turned the key on to prime. I do smell gas every once in a while it’s almost like a she dribbles during the prime but no pulse after that and I’ve got a rotation of four batteries standing by just to keep turning the motor over. I have gone...
  15. Ed Hardy

    91 suburban still Dead in the water no pulse at injectors

    pressure reading is only been done by turning of the key or remote starter button to turn the engine over and that is between 12 and 15 psi
  16. Ed Hardy

    91 suburban still Dead in the water no pulse at injectors

    Yes I have power at the injectors run and start not in off not in accessories. I have my own Homemade Noid LITE. It lights up with 12v and when you’re turning the key but you can’t really see if it’s flickering or not with a pulse but it’s definitely flickering with the turn of the engine...
  17. Ed Hardy

    91 suburban still Dead in the water no pulse at injectors

    Don’t quit Shirley I’ve been checking back and forth I have things other than this that are pressing, so I can’t always instantly reply back. sorry I bit so hard. I am I’m sorry you got admit though had a hard on for me The other night. And that being my first introduction ever to you or with...
  18. Ed Hardy

    91 suburban still Dead in the water no pulse at injectors

    Hi Shirley I'm sorry! That's what you call an instant, mutual rubbing of the fur in the wrong direction. I wasn't trolling hello I was looking for my replies and unfortunately he was the only one that replied. Replied in that manner my first experience with ol’Shirley. Don't quit and for damn...
  19. Ed Hardy

    91 suburban still Dead in the water no pulse at injectors

    I’m not ignoring anyone I don’t carry my phone around like most people do Its not attached to my hip. I go back read what’s been said and if I’m able I’ll give you a knod. check and I’ll do my best to reply. I am grateful for the help and that’s what I’ve been doing combing through wires again...
  20. Ed Hardy

    91 suburban still Dead in the water no pulse at injectors

    This is what I have, this is what I bought, and this is as far as I got, as far as a reading goes. They gave away entire story before it even got started good or even some would say, mediocre. She needed a tuneup and I thought well the computer knows everything and this handy-dandy “little...
  21. Ed Hardy

    Question concerning high fire ignition boxes

    If the box is the new fire controller wouldn't it eliminate the ECM and the spark control module in the distributor cap? I disconnected mine because I thought it was the problem. can I hooked this up at eliminate my brain? That's a question Apply put isn't it? Because if installing it it will...
  22. Ed Hardy

    91 suburban still Dead in the water no pulse at injectors

    As far as a soldering goes, I've never used anything but Nokorrode regular paste flux non-acidic and keister solder. No need to wipe clean but I do, knocks the greasiness down. And then I heat shrink right over top of it and seal it. I don't know it is crazy but I'm not using plumbers Flux I'm...
  23. Ed Hardy

    91 suburban still Dead in the water no pulse at injectors

    No scanner in the shop do not possess one she will run while I poured down again yes it is not a compression run it is a fire run. Has not started long enough to put any codes on episodes of last one that was on there which was 12 all fuses or not blown those are checked on a regular basis have...
  24. Ed Hardy

    Am I the only one that names my trucks?

    The widow maker and “Ben” there!
  25. Ed Hardy

    91 suburban still Dead in the water no pulse at injectors

    Check for shorts ohming out wires from distributor to ECM. Seems how I can't touch the wire at both ends with my leads hi test for shorts by touching one end of the wire and then to the chassis and see if I have a complete circuit and I have found that I do not possess a short. I am not blowing...

Latest posts

Members online

Total: 1,152 (members: 42, guests: 1,110)

Forum statistics

Threads
64,300
Messages
1,390,838
Members
51,360
Latest member
porky10001

Share this page

Top