Search results

T
Rippled rear frame horn

I know the rear of the truck was hit when owned by the previous owner.....I took down the spare and really see how bad it is. Lower frame is buckled and looks like someone welded a plate(s) to make it straight (take up the gap) and installed the hitch. Can someone post what it should look...
- Turbo86GN
- Thread
- Oct 24, 2023
- Replies: 3
- Forum: Lowered and Bagged Suspension
T
Door emblems with side trim

I installed new GM door trim on my '97 K2500 and noticed the emblem tabs are a lot smaller than the trim hole. Is there a clip that goes in the holes? I was thinking of just gluing the tabs + using two-sided tape.
- Turbo86GN
- Thread
- Sep 25, 2018
- Replies: 5
- Forum: Paint / Body / Detailing
T
L29 454 throttle screw

Hi all, I replaced the TPS since I got an intermittent TPS code (can't rem. what it was) and it had 179,000 miles on it. Now my idle is 2200 rpm in Park. Battery was disconnected for 40 min. and then ran it until warm (195 read on scan tool) but I still get the high idle. Everything is...
- Turbo86GN
- Thread
- Jan 7, 2017
- Replies: 0
- Forum: Engine Performance + Maintenance
T
1997 K2500 front driveshaft

What is the correct orientation for the shaft: is the slip joint closer to the diff or transfer case. On my old 1992 GMC, it was on the diff side but this truck had it on the transfer case side. Thanks, Mark
- Turbo86GN
- Thread
- Jun 21, 2016
- Replies: 2
- Forum: Axles + Brakes