Search results

  1. JACK34

    Truck idles rough at start up only.

    I have a 1994 with a 350 engine. I have replaced the distributer, IAC, TPS, coil, temp sensors, o2 sensor only had one and I removed the catalytic converter, tank and fuel pump are new and tested for pressure all good, fuel lines are new, cap and rotor, wires and plugs are new. Recently it...
  2. JACK34

    CAN I CUT MY EXHAUST OFF?

    My exhaust on my truck is stock from the engine to the cat. Then cut off around the back of the cab with a flowmaster Super 10 short type muffler. It only has one o2 sensor and it's on the front of the cat. If I cut it off in front of the cat I would have around 1 inch to weld new pipe to and...
  3. JACK34

    TRUCK IS ACTING CRAZY

    I have a 1994 Chevy 1500 with a 350. Last summer I replaced all the rear suspension, tank, fuel pump, fuel lines everything and a new rust free box. Around Feb it started to run a little rough nothing big I replaced the plugs and had the cap, rotor and wires put on my local mechanic because it...
  4. JACK34

    FRAME REBUILD/CLEANUP FROM CAB BACK

    Just got back to work on my 1994 this spring. Pulled the old box off and started in on the frame. Replaced all the spring hangers, shock hangers shocks, shackles, springs, u-bolts pretty much everything. New gas tank and fuel lines and fuel pump/sending unit and brake lines. If anyone is...
  5. JACK34

    FUEL LINE AND FUEL PUMP ADVICE

    I have a 1994 1/2 ton with a 350. Next spring I will be replacing the box. While I have the box off I plan on replacing things I can get at easy while I have the chance. One is the fuel pump, filter and all the fuel lines. I have been told you can get some type of flexible hose I'm not sure...
  6. JACK34

    TBI TO CARB CONVERSION

    I have a friend of mine who has I think a early model like 88 or 89 not sure. Anyway his problem is low power all kinds of things. He has taken it to professional mechanics and they can't figure it out. They have ruled out the the engine being bad. So what he has decided to do is take the...
  7. JACK34

    PAINT GUNS

    I have working on my truck, got a new box and plan on painting the whole truck next spring like hot rod matte black type finish. Anyway I have been experimenting with 2 cheap HVLP guns spraying automotive epoxy primer in one and Rustoleum in the other gun. Both 1.4 tips. They seem to work...
  8. JACK34

    SO I DON'T WANT TO PAINT MY TRUCK BUT I DO.

    I have a 1994 and just got a Texas rust free box. The frame is good the cab mounts and cab floor is good but needs cab corners and rockers and one front fender. I can do the rockers and cab corners. My main question is I just want the truck matte black. I'm not a painter but need some...
  9. JACK34

    RUST FREE BOX

    My truck bed fenders are doing what they do in the midwest rusting. The bottom of the bed inside the bed and the bed rails are fine. Starting to work on one fender but I'm wondering if I should just try and and find a whole new box. Any thoughts, prices I can expect anything would be helpful...
  10. JACK34

    Hello everyone I'm from where truck rust out

    Hey everyone thanks for allowing me here on this forum. I have a 1994 Chevy Silverado long bed standard cab half ton 2wd with a 350. I have had it about 6 yrs or so it's got 91,000 miles on it runs great but starting to rust out around the fenders on the box and rockers and cab corners. I...
Top